Bravo Ultrex Fungicide

Environmental Hazards

This product is toxic to aquatic invertebrates and wildlife. DO NOT apply directly to water, to areas where surface water is present, or to intertidal areas below the mean high watermark. Drift and runoff may be hazardous to aquatic organisms in neighboring areas. DO NOT contaminate water when disposing of equipment wash water or rinsate.

DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

DO NOT apply this product in a way that will contact workers or other persons, or pets either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

USE PRECAUTIONS AND RESTRICTIONS

• DO NOT use on greenhouse-grown crops.
• DO NOT combine Bravo Ultrex in the spray tank with pesticides, adjuvants, surfactants, or fertilizers unless your prior use has shown the combination physically compatible, effective, and noninjurious under your conditions of use. DO NOT combine Bravo Ultrex with Dipel®, Latron B-1956®, or Latron AG-98 as phytotoxicity may result from the combination when applied to some crops on this label.
• This product must not be applied within 150 feet for aerial applications, or 25 feet for ground applications of marine/estuarine water bodies, unless there is an untreated buffer area of that width between the area to be treated and the water body.

APPLICATION

Dosage rates on this label indicate pounds of Bravo Ultrex per acre unless otherwise stated. Under conditions favoring disease development the high rate specified and shortest application interval should be used.

The required amount of Bravo Ultrex should be added slowly into the spray tank during filling. With concentrate sprays, pre-mix the required amount of Bravo Ultrex in a clean container and add to the spray tank as it is being filled. Keep agitator running when filling spray tank and during spray operations.

Apply Bravo Ultrex in sufficient water to obtain adequate coverage of foliage. Gallonage to be used will vary with crop and amount of plant growth. For field and row crops, spray volume usually will range from 20 to 150 gallons per acre (200 to 1400 liters per hectare) for dilute sprays and 5 to 10 gallons per acre (50 to 100 liters per hectare) for concentrate ground sprays and aircraft applications. For tree and orchard crops, apply Bravo Ultrex in sufficient water and with proper calibration to obtain uniform coverage of tree canopy. For fruit and nut-bearing crops, the maximum volume is 300 gallons per acre unless indicated otherwise in the specific use directions. For conifers, the maximum volume is 100 gallons per acre.

APPLICATION INSTRUCTIONS

• ?Asparagus
  • Rust, Purple spot, Cercospora blight
  • 1.8 to 3.6 lb/A (1.5 to 3.0)
  • Use water volumes of 25 to 50 gallons per acre. Begin applications following the final harvest of spears. Repeat applications at 14- to 28-day intervals (the minimum retreatment interval is 14 days), depending on disease pressure. Use the higher rate and shorter interval if disease severity begins to increase during the season or weather conditions are conducive for severe epidemics. Apply by ground.
• Bean (Snap)
  • Rust (Uromyces appendiculatus)
    • 1.25 to 2.7 (1.0 to 2.2)
  • Botrytis blight (gray mold)
    • 2.7 (2.2)
  • Use in sufficient water to obtain adequate coverage. Begin applications during the early bloom stage or when the disease first threatens and repeat as necessary (the minimum retreatment interval is 7 days) to maintain control. Apply by ground, air, or chemigation.
• Carrot
  • Cercospora leaf spot
  • Alternaria leaf blight
  • 1.4 to 1.8 (1.2 to 1.5)
  • Use in sufficient water to obtain adequate coverage. Start applications when disease threatens and repeat at 7- to 10-day intervals or as necessary (the minimum retreatment interval is 7 days) to maintain control. Apply by ground, air, or chemigation.

*See label for the complete list of application rates.