Remington Solar Chlorine-Free Sun Shock

COMES WITH THE FOLLOWING ITEMS:

• Copper electrode
• Protective basket
• Ion test kit
• Mineral electrode cleaning brush

INITIAL ASSEMBLY

1. Lay the unit face down on a smooth surface.
2. With one hand, hold the spring electrode down in a compressed condition to avoid interference.
3. Thread either end of the mineral electrode clockwise onto the silver metal screw stud at the center of the unit, which is also at the center of the spring electrode.
4. Place screen cage over electrodes and line up centered holes with the threaded bore in the mineral electrode end.
5. Thread the white thumbscrew clockwise into the electrode and tighten finger tight, or snugly. Do not over tighten as the plastic thumbscrew will strip or break if over-torqued.

IMPORTANT NOTE TO FUNCTION PROPERLY:

Your Sun Shock WILL NOT WORK unless you check the following:

1. The copper anode must be screwed all the way into the top of the disk.
2. The coil and the copper anode cannot touch. Make sure that the groove in the bottom of the basket fits snugly around the bottom of the coil and screwed on tightly (with the white vinyl thumbscrew) to keep the coil and anode separate.