B&G 4 Way Tip Part 5800 - Questions & Answers

Displaying 1 to 8 (of 8 questions)
Sort:
  • Asked by Ryan
    09/13/2017
    Q
    How do I clean B&G 4 Way Tip Part 5800? What should we use to clean these tips?
    A

    Be sure that you rinse the unit out thouroughly after each use. You should use the B&G Deluxe Sprayer Maintenance Kit to clean your B&G 1 Gallon Sprayer.  It comes with solution, brushes, and full instructions from B&G to properly clean the sprayer.  Because the sprayer consists of brass and stainless steel you should use special brushes when cleaning which the kit comes with.

    Was this answer helpful to you?   Yes No
    2 of 10 people found this answer helpful.
  • Asked by Steven from Gettysburg Pa.
    06/11/2014
    Q
    what rate of spray is the fan tip, .02 ,.05 or .10 pg of water
    A
    We recommend contacting B&G directly at 1-800-544-8811 to get the rate of spray for the B&G 4 Way Tip Part 5800.
    Was this answer helpful to you?   Yes No
    0 of 1 people found this answer helpful.
  • Asked by George from Arlington, Va
    07/17/2016
    Q
    Will this B&G 4 Way Tip - Part 5800 tip fit the plastic part of the poly Dura Spray (10-PV), which I already own?
    A

    B&G 4 Way Tip - Part 5800 is a brass nozzle that will not fit onto a plastic wand such as found on the B&G 10PV Dura Spray.

    Was this answer helpful to you?   Yes No
  • Asked by Matt from Edmond, Ok
    09/09/2016
    Q
    Will this B&G 4 Way Tip - Part 5800 work with different sprayer brands?
    A

    We are not aware of B&G parts such as the B&G 4 Way Tip - Part 5800 working with other model sprayers.  

    Was this answer helpful to you?   Yes No
  • Asked by Josh from Florence, Az
    12/13/2016
    Q
    Will the B&G 4 Way Tip - Part 5800 work on a Birchmeier backpack sprayer?
    What spray nozzle would you recommend for pin stream and crack and crevices and also fine mist for a Birchmeier flux?
    A

    Unfortunately, the B&G 4 Way Tip - Part 5800 will not fit any Birchmeier sprayers. You would need to use the Birchmeier Duro Mist Nozzle 1.65MM that we have listed on our website.

    Was this answer helpful to you?   Yes No
    0 of 1 people found this answer helpful.
  • Asked by David from Los Angeles
    07/21/2017
    Q
    Does the B&G 4 Way Tip part 5800 include the washer to attach it to the spray handle?
    A

    No, the B&G 4 Way Tip Part 5800 does not include a washer.

    Was this answer helpful to you?   Yes No
  • Asked by Bill from Redding,ca
    03/06/2019
    Q
    Approximately how wide is the fan spray on the B&G 4 Way Tip Part 5800?
    A

    According to the manufacturer, the output of B&G nozzles is measured in degrees. The B&G 4 Way Tip Part 5800 sprays at a 50-degree angle. The manufacturer also stated that the height of the wand when spraying will also impact the width of the fan. The higher the wand is held the wider the fan will be and the opposite when it is lower or closer to the application site.   

    Was this answer helpful to you?   Yes No
  • Asked by Steve from Tn
    04/06/2021
    Q
    Does the B&G 4 Way Tip Part 5800 have thread that screw onto the wand?
    A

    No the B&G 4 Way Tip Part 5800 does not. You will need a tip retainer to attach it to the wand. 

     

    Was this answer helpful to you?   Yes No
Displaying 1 to 8 (of 8 questions)