Bifen XTS is labeled for army worms. You would mix 0.07-0.15 oz per 1000 square ft. The label states to ensure that the best control of Armyworms, Cutworms, and Sod Webworms is achieved, postpone watering or mowing for 24 hours following application.
The rate for Bifen XTS for webworms is not set per gallon but by area. You will use 0.07-0.15 fl oz per 1000 square feet. This generally mixes in 1-2 gallons of water. This can be done every 21 days as needed. To ensure that the best control of Armyworms, Cutworms, and Sod Webworms is achieved, postpone watering or mowing for 24 hours following application
No, Bifen XTS is not labeled for indoor use for fleas. We would recommend our Indoor Flea Kit. Here is a great video on how to use our Indoor Kit. You may also want to look over our Flea Control Guide for more information.
Bifen XTS will not harm trees if used as directed on the product label.
Bifen XTS can be applied any time of year depending on the insect(s) you are targeting.
While Bifen XTS can be used for ant control in general, unfortunately we cannot make recommendations for products used in a school environment. You will first need to contact your state Agricultural Dept. or school district for a list of approved products.
Bifen XTS cannot be used in a fogger.
Bifen XTS is an outdoor insecticide only and is not labeled for bedbugs. We recommend that you treat with one of our Bedbug Kits. Please find detailed information on treating for this insect in our How to Get Rid of Bedbugs Article.
Bifen XTS can be applied as directed monthly to the exterior listed areas. It is best to apply as a preventative. For additional information on timing in your area, you can contact your local cooperative extension office.
To treat ornamental plants for whiteflies, you can use 0.26 – 1.28 oz of Bifen XTS per 10 gallons of water, per the product label. The rate at which you set your hose-end sprayer will depend on what settings are available, although this is a pretty low rate per gallon of water with the highest rate being 0.128 oz per 1 gallon of water. 1 gallon of water usually treats about 1000 sq ft of turfgrass, so it will likely treat less area if you are treating dense ornamental growth. Be sure you are treating all the leaf surfaces until they are wet but not to the point of runoff.
Bifen XTS would not be safe on playground equipment surfaces that people come into contact with. You should only treat on the ground around the areas while no one is in the area during application then until dry, typicaly after 4-6 hours.
We would not recommend using Bifen XTS at temperatures over 85 degrees as this is an oil based product and can burn plants it comes into contact with under extreme heat. We recommend spraying in early morning or late evening.
Yes, Bifen XTS is labeled to control gypsy moth adults and caterpillars. Per the product label, be sure that you are also applying around the foundation of any structures as well as to the siding of the structure.
For use on edible plants or more sensitive plants, a product with Bt such as Natural Guard Caterpillar Spray with Bt is a great choice.
Bifen XTS can be used as a drench for some insects. However, it cannot be drenched on or around your vegetables. For termites around vegetables your best option is to use boiling water where you see activity.
Bifen XTS is not labeled for grubs. It is applied at the rate of 0.07-0.15 fl. ozs. per 1000 square feet for ants, armyworms and other listed pests and offers a 30 day exterior residual. You can see our full selection of grub control products here.
