Product Q&A

Answer:

We understand that it is tricky to know what setting to use on your spreader, but since there are so many available on the market, it is important to calibrate your own equipment based on your application and the product you are using. For Snapshot 2.5 TG, you will use 2.3 to 4.6 pounds of granules per 1,000 square feet. Please refer to the product label for the best rates for the area you are treating and the weeds you are targeting. Please see below for more details on how to calibrate your spreaders. Many folks will start at either the lowest setting or at 1 setting lower than the middle setting. We also have an excellent instructional video here. Almost all fertilizers, herbicides, insecticides, etc have treatments in amounts of so much product per 1000 square feet.  So if you can figure out what your walking speed is then you know anytime you apply any product that calls for so much of it per 1000 square feet, you always set your spreader on this setting.  You can calibrate this by marking off a 1000 square foot (10 x 100) area and placing 4 ounces of any type of product of similar granule size, or of the Snapshot in the spreader.  Start with a low setting and start walking your marked off area at a normal pace.  You can adjust as you go and find the basic setting for you to apply the product over a 1000 square feet. 

Answer last updated on: 03/15/2018

Was this answer helpful to you? Yes No

0 of 2 people found this answer helpful.