GrazonNext HL Herbicide is best applied when rain is not expected within 24 hours after application. As long as the weeds being controlled are not drenched/dripping water prior to application it can be applied after rain within a few hours.
There are no grazing restrictions using GrazonNext HL Herbicide. We would suggest they not be in the area during the application and while the surfaces are wet, once the treated surfaces are completely dry then they can return.
Without knowing the specific weeds you are targeting, we are unable to give an exact mix rate. GrazonNext HL Herbicide is applied at 19-34 fl oz per acre (43,560 sq ft). The amount of water will depend on how much water it takes to cover 1,000 sq ft thoroughly. Typically 1-2 gallons of water every 1,000 sq ft is sufficent, the label is recommending to use 3 gallons of water every 1000 sq ft to ensure the active ingredient in GrazonNext gets into the soil. Please see the break down below.
To treat each of the 5 acres, you would need 130 gallons of water for each acre. ** 1 acre = 130 gallons of water (3 gal of water x 43,560 sq ft (sq ft in acre)
You would need to refill your sprayer approx 3 times to thoroughly treat 1 acre.
Depending on what weeds you are targeting, you will divide the 19 fl oz, 24 fl oz or 34 fl oz mix rate per acre and divide by 3 (the # of times you will fill the 40 gal sprayer) .
Low Rate 19 fl oz / 3 tank fills = 6.3 fl oz per tank
Mid Rate 24 fl oz / 3 tank fills = 8 fl oz per tank
High Rate 34 fl oz / 3 tank fills + 11.3 fl oz per tank
You can mix the GrazonNext directly into the tank. To prepare the spray, add about half the required amount of water in the spray tank. Then, with agitation, add the specified amount of GrazonNext HL and other registered tank mix herbicides. Finally, with continued agitation, add the rest of the water and additives such as surfactants or drift control and deposition aids.
GrazonNext HL Herbicide is a post-emergent herbicide so it can be used any time the weeds are in an actively growing state. If the weeds are apparent now, then you can use the product now to try and eliminate them. The rate range for GrazonNext HL Herbicide is 1.2 to 1.5 pints (19 to 24 fluid oz) product per acre. Please provide details on your application for specific information.
Pets and people should be kept out of the area while GrazonNext HL Herbicide is being applied. Once application is complete and the area has been allowed to dry completely, it is safe for pets and people to return to the area.
For optimum uptake and translocation of the herbicide, avoid mowing, haying, shredding, burning or soil disturbance in treated areas for at least 7 days following application GrazonNext HL Herbicide.
The rate range for GrazonNext HL Herbicide is 1.2 to 1.5 pints (19 to 24 fluid oz) product per acre.
GrazonNext HL Amount (In fluid oz) To Mix In 3 Gal Of Water With Various Application Rates
GPA | 19 fl oz/A | 24 fl oz/A | 34 fl oz/A |
20 | 2.9 | 3.6 | 5.1 |
30 | 1.9 | 2.4 | 3.4 |
40 | 1.4 | 1.8 | 2.6 |
50 | 1.1 | 1.4 | 2.0 |
60 | 1.0 | 1.2 | 1.7 |
70 | 0.8 | 1.0 | 1.4 |
80 | 0.7 | 0.9 | 1.3 |
90 | 0.6 | 0.8 | 1.1 |
100 | 0.6 | 0.7 | 1.0 |
GrazonNext HL Herbicide is post-emergent and will not prevent seeds from germinating. Please check out our Pre emergent herbicides.
Weeds should be actively growing when treating with post-emergent herbicides such as GrazonNext HL Herbicide.If below 55 degrees then the target weeds will be dormant and a kill will not be likely.
There are no restrictions for when you can allow animals to graze on areas treated with GrazonNext Herbicide. We would always recommend waiting for the application to dry completely before allowing animals to re-enter a treated area. Please be sure to read the product label completely regarding restrictions on use of and transport of hay, use of manure, and movement of animals since manure and urine from animals consuming grass or hay treated with this product may contain enough aminopyralid to cause injury to sensitive broadleaf plants.
It is recommended that you wait until the next growing season to plant or reseed an area after treating an area with GrazonNext HL Herbicide. This is considered a vegetation management products and will kill and prevent anything from coming up for at least a year.
The rate at which you apply GrazonNext HL Herbicide will depend on the specific type of thistle you are treating. If you are treating yellow starthistle, bull thistle, musk thistle, or plumeless thistle, then you can use 1.2 - 1.5 pints per Acre, which would be 0.44 - 0.5 oz per 1,000 square feet. For sowthistle, prickly sowthistle, Canada thistle, or scotch thistle, you would use 1.5 - 2.1 pints per Acre, or 0.5 - 0.78 oz per 1000 sq ft. For spot treating with a 1-2 gallon sprayer, you would use the 1,000 sq ft rate in 1 gallon of water. For larger areas, the exact amount of water needed with depend upon your spray equipment and at what speed the product is applied. Please refer to the product label for complete application instructions.
Yes, you are able to reseed grass after using GrazonNext HL Herbicide. The label states that grasses may be reseeded in the fall following an application of GrazonNext HL applied in the spring or early summer.
There are no grazing restrictions for any type of livestock, including goats, when using GrazonNext HL Herbicide. We would suggest they not be in the area during the application and while surfaces are wet. Once the treated surfaces are completely dry then the cattle can return.
Yes, you can use GrazonNext HL Herbicide for suppression of blackberry plants in pastures at a rate of 1.5-2.1 pints per acre, per the product label.
GrazonNext HL Herbicide is labeled to treat for Ragweed and will do a fantastic job! The rate range is 1.2 to 1.5 pints (19 to 24 fluid oz) product per acre.
GrazonNext HL Herbicide can be applied anytime of the day but is best to not do so during the hottest time of day when desirable plants could be heat stressed.
Yes, GrazonNext HL Herbicide is safe for dairy cattle, and there are no restrictions of any kind on nursing dairy animals. You would use this at a rate of 2.1 pints per 1000 gallons of water with 2 pints of a non-ionic surfactant.
GrazonNext HL Herbicide should not be applied to Centipede turfgrass and should not be applied on lawns, turf, ornamental plantings, urban walkways, driveways, tennis courts, golf courses, athletic fields, commercial sod operations, or other high-maintenance, fine turfgrass areas, or similar areas.
Per the product label for GrazonNext HL Herbicide: Addition of Surfactants or Adjuvants on All Labled Use Sites: The addition of a high quality non-ionic surfactant (of at least 80% active ingredient) at 0.25 to 0.5 % volume per volume (1 to 2 quarts per 100 gallons of spray) is recommended.