Hi-Yield Turflon Ester Ultra is labeled to eradicate wild violets. Please refer to the product label for complete mixing and application instructions. You will mix 3/8 - 3/4 oz. per 1 gallon of water per 1,000 sq. ft. You can apply this product early spring through fall for the most effective results.
Per the Hi Yield Turflon Ester Product Label: Apply HI-YIELD® Turflon® Ester Ultra at a rate of 1 quart per acre. Three to four additional applications at 4 week intervals will be required to give adequate suppression of Bermudag- rass and allow Fescue or other desired turfgrass species to dominate. To improve suppres- sion and control of Bermudagrass, To improve suppression and control of Bermudagrass, tank mix 1 quart of HI-YIELD® Turflon® Ester Ultra per acre with a postemergence grass herbicide registered for this use pattern. Three to four additional applications of this tank mix at 4 week intervals should be made to achieve control. Reseeding following application will accelerate the transition to Cool Season turf.
This product only control weeds that have already emerged and that are actively growing. If your yard has started going dormant at all and your temps are not above 65 degrees at least 5 days in a row at this point in the year, then you need ot wait until next year to apply the product as you will only see spotty results now.
Hi-Yield Triclopyr Ester is best applied to dry areas. Slightly damp is ok but you do not want to apply when grass/weeds are soaked.
Hi-Yield Turflon Ester Ultra can be used on tall Fescue to control Bermuda grass. Per the product label, the application rate is 3/4 fl. oz. of product per gallon of water. You will likely have to do multiple applications to gain full control of the Bermuda grass. Applications can be done every 3-4 weeks.
It is recommended that you wait at least three weeks after applying Hi-Yield Triclopyr Ester Ultra to reseed.
Dish soap could interfere with the chemical process and prevent herbicides from doing their job. Hi-Yield Triclopyr Ester Ultra is applied at 3/8 - 3/4 oz. (2.25-4.5 teaspoons) per gallon of water per 1,000 sq. ft. (8 - 16 oz. per acre). See label for complete application instructions. It is recommended to add a non-ionic surfactant for best results but is not required per label instructions.
Hi-Yield Triclopyr Ester should be applied 2-3 days after mowing and you should not mow again for an additional 2-3 days after application.
Hi-Yield Turflon Ester Ultra could affect nearby desirable plants if it were to contact them or the root system. We would not recommend applying this product at or near the dripline of any desirable plants.
It can take about two weeks for Hi-Yield Triclopyr Ester to start to show burn down. You may need to make a 2nd application after four weeks.
Hi-Yield Turflon Ester Ultra is a selective post-emergent herbicide that will be most effective on young, actively growing weeds listed on the product label. It will be difficult to get control using post-emergent herbicides once temperatures are consistently less than 60 degrees and plants are beginning to go dormant.
Hi-Yield Triclopyr Ester Ultra is best applied in temperatures below 90 to prevent burning of the turfgrass and better effectiveness against the targeted weeds.
Pets should remain out of the treated area until the surfaces are completely dry. They should NOT be present during the application of Hi-Yield Triclopyr Ester Ultra.
Hi-Yield Triclopyr Ester can withstand rain 1 hour after application.
According to the Hi-Yield Triclopyr Ester product label, it is a herbicide used to control unwanted annual and perennial broadleaf weeds on perennial bluegrass, perennial ryegrass, and tall fescue ornamental turf (including sod farms, commercial turf, and golf courses). The label also states Hi-Yield Triclopyr Ester may injure certain turfgrass species. Do not apply to Bahiagrass, Bentgrass, Bermudagrass, Centipedegrass, St. Augustine grass, or Zoysiagrass, unless turf injury can be tolerated.