To treat brown patch using Prime Source Chlorothalonil 82.5DF Select on turfgrass, you would use 1.8 - 3.25 oz per 1,000 square feet. Using 1 oz per gallon of water would be fine if that gallon is only covering about 300-500 square feet. Typically 1 gallon of solution covers 1,000 square feet in a hand pump sprayer.
Prime Source Chlorothalonil 82.5DF Select is a dry flowable powder and is measured and distributed by weight in ounces.
Yes, Prime Source Chlorothalonil 82.5DF Select is labeled for Volutella Leaf Blight (Pachysandra). Per the product label you would apply at a rate of .125 oz per gallon to cover 1000 square feet. This product should be rainfast after about 6 hours.
Prime Source Chlorothalonil 82.5DF Select is not labeled to be applied as a drench. It offers a protective barrier so it should be applied directly to foliage. The foliar rate will vary depending on what you are treating. Please consult the product label to find the appropriate rate for your needs.
Prime Source Chlorothalonil 82.5 DF Select is not for use in any type of hose end applicator. It must be used in a tank sprayer and per the product label for brown patch is mixed at 1.82 to 3.25 ounces per 1000 sq/ft and can be reapplied every 7-14 days to maintain control of the disease and prevent it.
We apologize, but Prime Source Chlorothalonil 82.5DF Select is not labeled for use on residential lawns.
Prime Source Chlorothalonil 82.5DF Select is intended to be diluted with water and applied. Please refer to the product label for complete mixing and application instructions.
Prime Source Chlorothalonil 82.5DF Select does not state a specific rate for rust on spruce trees on the product label. For more information on this, we would recommend contacting the manufacturer (Prime Source) directly at 800-247-8013.
Prime Source Chlorothalonil 82.5DF Select Fungicide does not come with a measuring device however here is the dry ounce measurement coverted to teaspoons for easier measuring.
The rate of 1.82 to 3.25 ounces per 1000 sq ft would be equal to 10.5 teaspoons (3.5 tbsp) to 18.7 teaspoons (6 1/4 tbsps) per 1000 sq ft.
Chlorothalonil 82.5DF Select is not labeled for use on spruce trees.
We do carry Garden Tech Daconil Fungicide that can be applied to spruce trees for treating this fungus.
Prime Source Chlorothalonil 82.5DF Select Fungicide is a dry flowable concentrate, so it is important to mix the product well while mixing and agitate during spraying to insure an even application. If the spray is allowed to settle, then some of the carrier and/or active ingredient may settle in the tank.
Per the product label: Slowly invert container several times to assure uniform mixture. Measure the required amount of Prime Source Chlorothalonil 82.5DF Select Fungicide and pour into the spray tank during filling. Keep agitator running when filling spray tank and during spray operations.
The most accurate method to measure dry flowable powders would be to use a digital weight scale similar to what you would use to measure portions for food. Place a disposable plastic cup on the digital scale, zero the scale to 0.00 with the cup on the scale, slowly add the amount of Prime Source Chlorothalonil 82.5DF Select to the cup until you have the product label rates for your treatment in ounces measured.
Please view the full product label for more information.
Prime Source Chlorothalonil 82.5DF Select Fungicide is intended for the following larger areas and has been discontinued: Commercial: Golf courses (Cool & Warm-Season Turf-grass), Landscape Ornamentals (100 gallons of water (0.9 to 2.5 lbs) and Conifers (1 acre (1.36 to 5 lbs). For smaller beds, Garden Tech Daconil Fungicide Concentrate kills and prevents more than 80 types of plant diseases. It can be used on flowers, vegetables, fruit, and shade trees, and shrubs to control problems such as leaf spots, blights, rust, mildew, and fruit rot, and many others.
