Seaira Global Watchdog NXT60 Dehumidifier

SPECIFICATIONS:

• Rated Condensate Capacity (80?F, 60%) - 60 Pints Per Day
• Rated Condensate Capacity (90?F, 90%) - 120 Pints Per Day
• COP - 2.45 L/kWh
• Refrigerant - R410A
• F.L.A. at Rated Conditions (80?F, 60%) - 4.05A
• Airflow @ 0.00” S.P. - 155 CFM
• Inlet Filter - MERV-10
• Supply Duct (optional) - 10” Collar
• Return Duct (optional) - 10” Collar
• Sound Level - 59 dBa
• Drain Connection - 12” Tube
• Coverage Area - 11,000 cubic feet
• Power Cord - 10’
• Operating Temperature Range - 33-105 degrees F
• Operating Relative Humidity Range - 36-90%
• Weight - 56 lbs.
• Dimensions L x W x H - 21.7” x 12” x 12”
• Warranty - 5 Years
• Power Supply - 115V/60 Hz

HOW ITS WORKS

WatchDog dehumidifiers use an integrated humidistat to monitor the conditioned space. When the relative humidity goes above the selected setpoint, the dehumidifier will energize. Air is then drawn across an evaporator coil, which is cooler than the dew point of the air. This means moisture will condense out of the air. The air is then reheated through the condenser coil and distributed back into the room.

INSTALLATION

1. Place dehumidifier on a level surface.

• Do not place the unit directly on the vapor barrier. For example, use blocks or pavers to create a level surface.
• If the unit has been turned or flipped so that the compressor did not remain upright, place the unit on a level surface and wait a minimum of 2 hours before proceeding.

2. Set up the drain line

• The drain line should be routed to a suitable drain on the outside.
• THE DRAIN MUST FLOW DOWN WITH NO LOOPS OR DIPS.
• Recommended Drain Option- Transition to PVC Pipe
  • ?Cut a piece of 3/4” OD PVC that is approx. 6” long.
  • Insert cut PVC into a 3/4” elbow.
  • Attach PVC+elbow to a 3/4” OD length of PVC to drain. Keep the length of PVC as short as possible.
  • Insert the open end of the dehumidifier drain tube into 6” piece of PVC so that it does not extend into elbow fitting.
  • For a proper flow, a minimum downward slope of 1” per 10’ run is required.
  • Support the PVC tubing so that it maintains a smooth downward flow to drain.
• Plug unit into a dedicated 15 amp GFCI outlet.

OPERATING INSTRUCTIONS

• ?Start the machine
  • Press the power key to turn the dehumidifier on.
• Adjust the settings
  • Use the up and down arrow keys to adjust your desired setpoint (typically 50-55%)
• Stop the machine
  • Press the power button again and the dehumidifier will stop. Note that the fan will continue to operate for 1 minute after the unit has shut off. DO NOT DISCONNECT THE POWER CORD TO FORCE THE UNIT TO STOP.
• Water Drainage
  • During normal operation, the dehumidifier will automatically drain due to gravity.
  • If you want to move or store the machine, wait at least 10 minutes to allow the unit to completely defrost.
  • Once defrosted, lean the dehumidifier gently towards the drain to ensure it is completely dry.