Prime Source AzTeb Select Fungicide

APPLICATION INSTRUCTIONS:

Apply AzTeb Select at rates and timings as described in this label.

MIXING INSTRUCTIONS:

• To prepare spray solution, partially fill the spray tank with clean water and begin agitation. Add the specified amount of AzTeb Select to the tank, allowing time for good dispersion, then add an adjuvant, if recommended. If tank mixes are required, product should be added to the spray tank in the following order; AzTeb Select, wettable granular or dry flowable formulations, wettable powders and flowable (aqueous suspensions) products. Finish filling the tank to the desired volume to obtain the proper spray concentration. Maintain agitation throughout the spraying operation.
• Do not allow spray mixture to stand overnight or for prolonged periods. Make up only the amount of spray required for immediate use. Sprayers should be thoroughly cleaned immediately after application.
• Do not use silicone-based products with AzTeb Select due to possible phytotoxicity.
• AzTeb Select is compatible with many commonly used fungicides, liquid fertilizers, herbicides, insecticides, and biological control products. If tank mixes are desired, observe all directions, precautions, and limitations on labeling of all products used.
• Consult compatibility charts or your local or State turf authority for compatibility information. Do not combine AzTeb Select in the spray tank with pesticides, surfactants, or fertilizers, unless compatibility charts or your own prior use has shown that the combination is physically compatible, effective, and non-injurious under your conditions of use. If physical compatibility is unknown, the following procedure should be followed: pour the recommended proportions of the products into a suitable container of water, mix thoroughly and allow to stand at least twenty (20) minutes. If the combination remains mixed or can be re-mixed readily, the mixture is considered physically compatible.

LABELED DISEASES:

• Anthracnose
• Brown patch
• Brown ring patch
• Cool weather brown patch
• Fairy ring
• Gray leaf spot
• Gray snow mold
• Leaf spot
• Leaf and sheath spot
• Leaf rust
• Melting out
• Microdochium patch
• Necrotic ring spot
• Pink patch
• Pink snow mold
• Powdery mildew
• Pythium blight
• Pythium root rot
• Red thread
• Rhizoctonia large patch
• Spring dead spot
• Stem rust
• Stripe rust
• Southern blight
• Summer patch
• Take-all patch
• Typhula blight
• Yellow patch
• Zoysia patch

RESTRICTIONS:

• Observe the following restrictions when spraying in the vicinity of aquatic areas such as lakes, reservoirs, rivers, permanent streams, marshes or natural ponds, and estuaries.
• Do not apply by ground within 100 feet of aquatic areas listed above
• Do not cultivate within 10 feet of an aquatic area to allow the growth of a vegetative filter strip.
• Do not spray AzTeb Select where spray drift may reach apple trees.
• Do not apply when weather conditions favor drift from treated areas to non-target aquatic habitat.
• Do not spray when conditions favor drift beyond the area intended for application.
• Do not use spray equipment that has been previously used to apply AzTeb Select to spray apple trees. Even trace amounts can cause unacceptable phytotoxicity to certain apple and crabapple varieties.
• Do not apply AzTeb Select to the turf by air.

Registered States: AL, AR, CO, CT, DE, FL, GA, IA, ID, IL, IN, KS, KY, LA, MA, MD, ME, MI, MN, MO, MS, MT, NC, ND, NE, NH, NJ, NM, NV, NY, OH, OK, OR, PA, RI, SC, SD, TN, TX, UT, VA, VT, WA, WI, WV, WY