Snapshot 2.5 TG can be applied to damp ground from dew or a previous rain, but you would not want to apply when the ground is saturated or holding water. Snapshot does need to be activated by water within 3 days of application to be effective.
Yes, Snapshot 2.5 TG - 50 lbs. can be used in Oregon.
Snapshot 2.5 TG should not be applied to turf grasses. Snapshot 2.5 TG is meant to be used in landscape beds and around trees. We do carry pre-emergent herbicides such as Andersons 0.48 Barricade Herbicide that can be used on turf grasses like St. Augustine grass.
Yes, you can apply Snapshot 2.5 TG Herbicide over container-grown or field-grown Asian jasmine. Be sure that you water in the product as directed on the product label to release the active ingredient and carry it into the soil below the plants.
Snapshot 2.5 TG may be applied following bulb emergence but should not be applied to bulbs while they are flowering per the manufacturer. Please refer to the product label for specific application instructions for this area.
As we do not offer Freehand on our site you would just need to refer to the product label for instructions on this product.
Per the Snapshot 2.5 TG label, you can apply Snapshot to fall planted bulbs for winter weeds. In the spring you will need to make another application for late spring/summer growing weeds.
Ornamental Bulbs Do not use Snapshot 2.5 TG in bulb production flelds. For use in landscape settings only.Snapshot 2.5 TG may be applied for control of susceptible annual weeds in ornamental bulbs, e.g., bulbous iris, daffodil (narcissus), hyacinth and tulip. Apply Snapshot 2.5 TG to the soil surface 2 to 4 weeks after planting, but prior to the emergence of annual weeds. Snapshot 2.5 TG may also be applied following bulb emergence but prior to fiowering and after fiowering. For fall planted bulbs, apply Snapshot 2.5 TG again in late winter or early spring to weed-free soil surfaces.
You need to keep Snapshot 2.5 TG out of the root zone of your vegetable plants. Best to keep at least 10-15 feet away.
Fusilade is a good option to use for crabgrass and other grassy weeds in juniper as directed on the product label. As far as timing for a pre-emergent like Snapshot, it should be applied before soil temperatures reach 55 degrees. If the Snapshot did not prevent the crabgrass it sounds like it was applied too late. You may also contact your local cooperative extension office to determine the correct timing of the application as this will vary greatly from region to region.
Snapshot 2.5 TG is a pre-emergent herbicide that needs to be activated with about 0.5 inches of rainfall or irrigation. If you are expecting extremely heavy rains, then it would be best to delay your application so that your barrier is not disturbed. Snapshot should be activated within 3 days of application for best results. Repeat applications at 150 lbs per Acre or higher should not be made sooner than 60 days, per the product label.
Since Snapshot 2.5 TG is a pre-emergent, meaning that it prevents seeds from germinating, you should not plant any seeds you want to grow and germinate for at least 1 year after applying per the product label.
Snapshot 2.5 TG would be best applied after you have planted so that the soil is not disturbed and the barrier removed while you are planting. . Apply Snapshot 2.5 TG anytime prior to germination of target weeds, or immediately after cultivatition
The complete list of tolerable plants including palms that Snapshot 2.5 TG can be used on is found on the label here.
Snapshot 2.5 TG cannot be used in areas where edibles are planted, or in areas that are being prepared for edibles to be planted. Casoron 4G is labeled for use around blueberries. It should be applied in the fall, once soil temperatures have dropped below 70 degrees and in the spring before soil temperatures have reached 50-55 degrees. The label states it should not be applied to blueberries until 4 weeks after transplanting.
Snapshot 2.5 TG lists several species of oak on the label as tolerable but does not specify blue oak. We would recommend reaching out to the manufacturer directly to confirm if there is not an issue, Dow can be reached at 800-992-5994.
Yes, Snapshot 2.5 TG would be safe to use in an established ornamental area as directed on the product label.
Snapshot 2.5 TG can be reapplied in 60 days after the first application if needed for prevention. How often depends on the program you are using. Do not exceed the labeled per acre total within a 12 month period.
Snapshot 2.5 TG is safe when used according to the product label. Ideally you would want to apply on a day with no wind to minimize excess drift of the product into non target areas. If you are wearing the proper PPE (personal protective equipment) as listed on the Product Label- long sleeve shirt, long pants, shoes plus socks- then there should be minimal chance of the product contacting your skin. If some does blow and touch your skin, just rinse and wash it with soapy water.