VectorFog DH1 Gel Bait Gun - Questions & Answers

Displaying 1 to 3 (of 3 questions)
Sort:
  • Asked by Jason from Jensen Beach, Fl
    11/17/2015
    Q
    Can you adjust how much bait is applied when using the VectorFog DH1 Gel Bait Gun?
    Is there another way besides just pulling the trigger less? Can you set it so the trigger will stop when the proper amount of bait is applied?
    A

    There is a pin on the side of the VectorFog DH1 Gel Bait Gun that can be pulled out and adjusted to release the amount of bait gel you would like to apply to a particular area. The settings are "L" for low dosage and "H" for high dosage. This is the only way the amount of bait gel can be measured with this bait gun.

    Was this answer helpful to you?   Yes No
    3 of 3 people found this answer helpful.
  • Asked by Adam from Midland
    08/17/2015
    Q
    Does the VectorFog DH1 Gel Bait Gun come with a refillable cartridge?
    A

    The VectorFog DH1 Gel Bait Gun, as all bait guns, does not come with any bait. This gun can be used to apply most gel baits that come in 30-35 g tubes.

    Was this answer helpful to you?   Yes No
    2 of 2 people found this answer helpful.
  • Asked by Jose from Jackson Heights
    03/16/2017
    Q
    Is all of the VectorFog DH1 Gel Bait Gun made of steel or just some of the parts?
    because i need to buy tre of this but i need to know if all the product is a steel thank you very much
    A

    The VectorFog DH1 Gel Bait Gun  handle assembly is a sturdy plastic and the rod is made from Japanese steel. 

    Was this answer helpful to you?   Yes No
Displaying 1 to 3 (of 3 questions)