Displaying 1 to 5 (of 5 reviews)
9 of 9 people found this review helpful:
By Dan on 03/03/2015
My elderly parents house was being over run with mice, so I was called upon to close up the multiple entry points. Since the house is over 90 years old, the challenge was finding something that would fill the variety of openings. Cutting, wrapping, and rolling the Xcluder material into various shapes worked well in filling the larger gaps. Cutting the material is a challenge. I ultimately ended up using a pair of tin snips. The wire strands will go everywhere, so gloves and eye protection is a must.
7 of 7 people found this review helpful:
By James on 09/11/2015
Wonderful product. You don't need tin snips or scissors to cut-just pull apart the amount you need. I like the fact that it won't rust-SS Steel. Definitely wear leather gloves and be careful not to breath in the floating dust-polymers. OK to use outside but use a dust mask for indoor work. One note. It will burn with DIRECT flame-I would be Leary about putting it around a flash water heater exhaust.
4 of 4 people found this review helpful:
By Dale on 06/21/2016
Works great filled cracks and openings around house. Price is a little high
1 of 1 people found this review helpful:
No mice for the 1st time in 40 years
By Criag on 03/20/2017
I would get mice in my basement every winter no matter what I did. Last winter was really bad for my basement, 8 mice in traps. In the fall I installed Xcluder 4", cut into 2" strips, in the gap at the cinder block foundation wall and the siding. I folded the cloth in half and pushed it into the gap with a putty knife, be sure to wear gloves. It's now mid March without one mouse. It cost a bit but I'm saving money on traps, time and cheese. Thank you Xcluder
By Chris on 12/08/2017
I used this material in my RV to prevent Rats and other rodents getting in. The material slows them down, but does not stop them. They eventually pull and tear the material and gain access again.