Alto 100 SL Fungicide is a specially formulated fungicide that provides powerful control of various cereal diseases. Contains Cyproconazole as its active ingredient which provides curative broad-spectrum control of diseases. It prevents soybeans, wheat, and peanuts from certain diseases.Alto 100 SL Fungicide is proven to be long-lasting and convenient to use because it offers a wide application window. It is highly systemic plus it provides excellent residual activity. Compatible to be tank mixed with numerous tank mix partners but jar test is still recommended. This fungicide is cost-saving since it utilizes low use rate and it is also safe to use on crops. Targets and controls diseases such as rusts, foot rot, powdery mildew, leaf blight, spot blotch, tan spot, septoria leaf blight, Helminthosporium leaf blight, and glume blotch. Available in a gallon jug.
FAILURE TO FOLLOW THE USE DIRECTIONS AND PRECAUTIONS ON THIS LABEL MAY RESULT IN PLANT INJURY, POOR DISEASE CONTROL AND/OR ILLEGAL RESIDUES.
Methods of Application
Alto 100SL Fungicide may be applied via ground, by air, or chemigation depending on the crop. Refer to Section 7.0 for crop-specific instructions.
Alto 100SL Fungicide may be applied with all types of spray equipment commonly used for making ground and aerial applications. Do not apply Alto 100SL Fungicide through any type of ultra-low volume (ULV) spray system. Proper adjustments and calibration of spraying equipment to give good canopy penetration and coverage is essential for good disease control.
Equip sprayers with nozzles that provide an accurate and uniform application.
Be certain that nozzles are the same size and uniformly spaced across the boom.
Calibrate sprayer before use.
Although Alto 100SL Fungicide is a soluble concentrate, it is suggested that screens be used to protect the pump and to prevent nozzles from clogging.
Screens placed on the suction side of the pump should be 16-mesh or coarser.
Do not place a screen in the recirculation line.
Use 50-mesh or coarser screens between the pump and boom, and were required at the nozzles.
Check nozzle manufacturer’s recommendations.
Use a pump with capacity to:
Maintain at least 35 - 40 psi at nozzles.
Provide sufficient agitation in tank to keep the mixture in suspension (this requires recirculation of 10% of tank volume per minute).
Use a jet agitator or liquid sparge tube for agitation.
Do not air sparge.
For more information on spray equipment and calibration, consult sprayer manufacturers and state recommendations. For specific local directions and spray schedules, consult the current state and local agricultural recommendations.
Application Volume and Spray Coverage
Apply Alto 100SL Fungicide in a minimum spray volume of 10 gallons per acre for ground application, and 2 gallons per acre for aerial application. Use sufficient water for adequate coverage and canopy penetration.
Thoroughly clean spray equipment before using this product.
Prepare no more spray mixture than is required for the immediate operation.
Keep product container tightly closed when not in use.
Agitate the spray solution before and during application.
Do not let the spray mixture stand overnight in the spray tank.
Rinse spray tank thoroughly with clean water after each day’s use and dispose of pesticide rinsate by application to an already treated area.
How much Alto 100 SL Fungicide would you mix per gallon?
Per the label, you would apply Alto 100 SL Fungicide at a minimum spray volume of 10 gallons per acre for ground application, and 2 gallons per acre for aerial application. Please see the label for complete application instructions.