DIRECTIONS FOR USE

For best results place stations in shaded areas or create shade for the bait station. Avoid placing bait station where it will receive direct sunlight whenever possible.

For use around structures:

The number of bait stations to use will vary with the type of ant and the size of the colony.

For initial placement:

Place one bait station every fifty feet around the structure to be treated.

If any of the bait stations are emptied in less than a week, double the initial placement. Replace baits as needed until feeding activity ceases.

To Activate and Place the Antopia R6 Bait Station

Loosen the soil in the spot where you are going to place the station to a width of about 3" an a depth of about 7" with a garden trowel or small shovel.

Remove seal at the end of the entry tube to expose the bait station entryway.

Place the anchor into the soil with a clockwise turning motion until the entryway is level with the soil. If you encounter difficulty in seating the bait station properly, remove it and loosen the soil more thoroughly, then repeat the anchoring process.

Alternatively, dig a small hole to a depth of 7" place the station in the hole, so that the entryway is level with the adjacent ground, and replace the soil.

TO REUSE ANTOPIA R6 BAIT STATION

If less than six months from first use, remove cover and add bait of the same type previously used. If spill resistance is desired, fill station to approximately six fluid ounces. If more than six months since first use or last cleaning, empty bait station completely, disposing of uneaten bait in accordance with label directions; fill bait station with mild bleach solution (1% chlorine) and allow to sit for at least one hour; empty bait station and dispose of rinsate properly; rinse bait stations several times with water or mild soap and water solution; dispose of rinsate properly and allow station to dry. Add bait through top fill port to six fluid ounce level; replace fill port cover and place station as directed.