Yes, Dimension 2EW is safe to use on well established St. Augustine lawns. What season you need to begin applications and usage rate will depend on what you are treating. Pages 4 and 5 of the Dimension 2EW Herbicide Label gives you the 3 different options for treatments programs. As for discounts, we do run periodic specials and coupons which we email to our customers that have signed up to receive coupons from us and we always offer a low price guarantee and free shipping.
You will use .33 - .73 of an ounce of Dimension 2EW per 1,000 sq ft. The exact usage rate will depend on your location and the application program you choose. Please refer to pages 4-6 of the Dimension 2EW Herbicide Label to find the exact usage rate for your needs.
You will need .75 - 3.0 pints of Dimension 2EW per acre. The exact amount you will need will be based on what region you are located in and what program you choose. Please refer to page 5 of the Dimension 2EW Herbicide Label for more specific information.
Both Dimension and Gallery are great pre-emergents and are OK for use around non-bearing vineyards only. We do not currently carry any pre-emergents that can be used around bearing vineyards.
Centipede is listed as a tolerant grass on the product label. Be sure to read and follow the directions on the Dimension 2EW product label for best results.
To prevent sandburs you should apply Dimension 2EW Herbicide as a pre-emergent in the late fall. Be sure to read over the product label for complete instructions. Sandburs are easier to prevent than to try to get rid of once they have invaded your yard.
Herbicides are a lot different than other concentrated products and can be hard to understand at first. The application rate depends on the the type of turf you have and how quickly you apply the product. You will need to read the product label to determine the correct usage rate for your needs (you did not give us any information about the type of lawn, region or application program you will be using so we cannot give you exact rates). The amount of water used to apply Dimension herbicide is not critical, but should be sufficient for uniform coverage of the target area. Calibrate by determining the volume of water required to treat 1,000 square feet. Use this calibration volume to determine the amount of water and Dimension herbicide needed to treat the target area (see the following calibration example). Note: Sprayer calibration (volume of spray needed to treat 1,000 square feet) will vary with each individual operator.
Steps in Calibration:
1. Mark an area of 1,000 square feet (i.e. 20 by 50 feet or 25 by 40 feet).
2. Place the sprayer on a level surface and add water noting the final level of water in the spray tank.
3. Spray the marked area with a sufficient volume of water to provide uniform coverage. Refill the sprayer to the same level as before measuring the amount of water added. The measured water added to the sprayer is the volume needed to cover 1,000 square feet.
4. Determine the application rate (0.073- .55 fl. oz./1,000 sq. ft.) for Dimension from the Recommendations section of this label.
5. To each volume of water used as measured in step 3, add the amount of Dimension as determined in step 4.
Example: If the sprayer uses 1 gallons of water to cover 1,000 square feet and the desired application rate of Dimension is .55 fluid oz./1,000 square feet, then you would add .55 fluid ounces of Dimension to every 1 gallon of water to be used."
If you still find you need help figuring out the correct usage rate (we know this label is confusing) please don't hesitate to call us and let one of our customer service representatives help you 866-581-7378 (M-F 9-5 EST)