Per the product label, you want to wait at least 7 days following the application of GrazonNext HL Herbicide to mow.
GrazonNext HL Herbicide is not lableded to treat sedge. We have several products labeled for sedge that can be found here.
GrazonNext HL Herbicide is safe for pastures but it is not specifically labeled to control sida rhombifolia.
GrazonNext HL Herbicide is labeled for use around livestock and is safe when applied as directed.
Yes, you may use a surfactant like Non-Ionic Surfactant for Herbicides to increase the effectiveness of GrazonNext HL Herbicide.
The dilution rates for GrazonNext HL Herbicide will vary depending on the weeds you are targeting and the application site. Please refer to the product label for the appropriate rate for your needs. Also, please keep in mind that this product should only be used on pastures and other areas approved on the product label, not on residential lawns.
Yes, GrazonNext HL Herbicide is labeled to kill buckhorn plantain.
You will mix the GrazonNext HL Herbicide at 1.5 pints (24 oz) per 40 gallons of water per acre. For tough to control weeds you may use up to 2.1 pints (34 oz) per acre. Please review the product label for more information.
The amount of GrazonNext HL Herbicide can vary based on how much water is required to thoroughly spray the foliage to the point of run off. Please refer to Table 1 and Table 2 on pages 4 & 5 of the product label. It is advised that the total amount of GrazonNext HL applied broadcast, as a re-treatment, and/or spot treatment per year must not exceed 2.1 pints (34 fluid oz) per acre. Spot treatments may be applied at an equivalent broadcast rate of up to 4.2 pints (68 fluid oz) per acre of GrazonNext HL per annual growing season; however, not more than 50% of an acre may be treated at that rate.
GrazonNext HL Herbicide is applied at 19-34 fl oz per acre (43,560 sq ft) for horse nettle/bull Netle. The amount of water will depend on how much will cover a 1,000 sq ft uniformly usually 1-2 gallons of water per 1,000 sq ft.
GrazonNext HL Herbicide is labeled to treat dandelions. Please note, the label does state: Do not apply this on lawns, turf, ornamental plantings, urban walkways, driveways, tennis courts, golf courses, athletic fields, commercial sod operations, or other high-maintenance, fine turfgrass areas, or similar areas.
GrazonNext HL Herbicide is not labeled to treat leafy spurge or whitetop. The labeled rate for knapweed and gumweed is 24-34 ounces of GrazonNext HL Herbicide per acre.
Exactly how much GrazonNext HL Herbicide you use per 25 gallon tank will depend on how large of an area that 25 gal tank covers. For wormwood control, you should use 19-24 fl oz of GrazonNext per Acre (0.44-0.55 oz per 1000 sq ft) in sufficient water. So if your 25 gal tank covers ½ Acre, then you would use 9.5 – 12 oz in that tank. Please refer to the product label for complete application instructions.
Since we do not carry the Gly Star Plus, we cannot say for sure whether it can be mixed with GrazonNext HL. We can tell you, though, that most herbicides are labeled as safe to be mixed with other EPA-registered herbicides. We recommend that you read and follow the label instructions for each product to prepare a tank mix test and see if the two products are indeed compatible.
Tpyically, truck spray rigs are 25, 50, or 100 gallon tanks. Keep in mind that larger tanks may require more agitation ability since you would be refilling less frequently. Usually for herbicides you should use at least 30 gallons of water per Acre for most applications. There are likely larger tanks for more complex systems with mechanical booms, however, we do not specialize in this type of agricultural equipment.
The high rate of Grazon Next HL would be 34 oz per acre. You would need 1700 oz to treat the 50 acres. The total water needed will be determined by the spray rate you’re applying. You will need to know how many gallons your spraying per acre, then apply 34 oz for that amount.
Per the GrazonNext Product Label: Spot Application: Spot treatments may be applied at rates equivalent to broadcast-applied rate of up to a maximum of 4.2 pints (68 fl oz) on 50% of the treated field. Spray volume should be sufficient to thoroughly and uniformly wet weed foliage. Repeat treatments may be made, but the total amount of GrazonNext HL applied must not exceed 2.1 pints (34 fl oz) per acre per year (see comments in the Use Precautions and Restrictions section above on Maximum Application Rate).
The dilution rates for GrazonNext HL Herbicide will vary depending on the weeds you are targeting and the application site. Please refer to the product label for the appropriate rate for your needs.
No, GrazonNext HL Herbicide is not labeled for crabgrass. We carry a full line of products for Crabgrass Control that can be found here.
Per the product label, you want to wait at least 7 days following the application of GrazonNext HL Herbicide to mow.
