Inspire Fungicide

PRODUCT USE INSTRUCTIONS:

Application:

Thorough coverage is necessary to provide good disease control. Make up no more spray solution than is needed for application. Avoid spray overlap, as crop injury may occur.

MIXING INSTRUCTIONS:

• Prepare no more spray mixture than is required for the immediate operation.
• Thoroughly clean spray equipment before using this product.
• Agitate the spray solution before and during application.
• Rinse spray tank thoroughly with clean water after each day’s use and dispose of pesticide rinsate by application to an already treated area.

Inspire Alone (no tank mix):

• Add 1/2 - 2/3 of the required amount of water to the spray or mixing tank.
• With the agitator running, add Inspire to the tank.
• Continue agitation while adding the remainder of the water.
• Begin application of the spray solution after Inspire has completely dispersed into the mix water.
• Maintain agitation until all of the mixture has been sprayed.

Inspire + Tank Mixtures:

Inspire is usually compatible with tank-mix partners. To determine the physical compatibility of Inspire with other products, use a jar test. Using a quart jar, add the proportionate amounts of the products to 1 qt of water. Add wettable powders and water dispersible granular products first, then liquid flowables, and emulsifiable concentrates last. After thoroughly mixing, let stand for at least 5 minutes. If the combination remains mixed or can be remixed readily, it is physically compatible. Once compatibility has been proven, use the same procedure for adding required ingredients to the spray tank.

Mixing in the Spray Tank:

• Add 1/2 - 2/3 of the required amount of water to the spray or mixing tank.
• With the agitator running, add the tank-mix partner(s) into the tank in the same order as described above.
• Allow the material to completely dissolve and disperse into the mix water. Continue agitation while adding the remainder of the water and Inspire to the spray tank.
• Allow Inspire to completely disperse.
• Spray the mixture with the agitator running.
• Observe all directions for use, crops/sites, use rates, dilution ratios, precautions, and limitations which appear on the tank mix product label.
• Label dosage rate must not be exceeded, and the most restrictive label precautions and limitations must be followed.
• This product must not be mixed with any product which prohibits such mixing.
• It is the pesticide user’s responsibility to ensure that all products are registered for the intended use. Read and follow the applicable restrictions and limitations and directions for use on all product labels involved in tank mixing. Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture.

APPLICATION PROCEDURES:

Ground Application:

• Apply in a minimum of 10 gal of water per acre, unless specified otherwise.

Aerial Application:

• Use only on crops where aerial applications are indicated.
• Apply in a minimum of 5 gal of water per acre, unless specified otherwise. For pome fruit apply in a minimum of 10 gal of water per acre.
• Do not apply under conditions when uniform coverage cannot be obtained or when excessive spray drift may occur.
• Do not apply directly to humans or animals.

SEE LABEL FOR COMPLETE INSTRUCTIONS.

Environmental Hazards:

This pesticide is toxic to fish, mammals, and aquatic invertebrates. Drift and runoff may be hazardous to aquatic estuarine/marine organisms in water adjacent to treated areas. Do not apply directly to water, or to areas where surface water is present or to intertidal areas below the mean high water mark. Do not contaminate water when disposing of equipment washwater or rinsate.