Test bait stations for fit by inserting stake end through hole at front of bait station. Hammer stake into ground or asphalt making sure to leave top end of stake with hole exposed. Leave enough of stake to allow easy insertion of washer and cotter pin.
Place Bait Station over stake and set Bait Station flush on ground or asphalt.
Set washer over stake.
With washer installed over stake and hole in stake above the washer, insert pin by pushing straight part of pin into hole until both curved parts of pin pass over the securing stake.
After washer and cotter pin is installed, pound stake down until washer is tight against Bait Station. Then fill proper compartment with J.T. Eaton Bait Blocks and attach and secure lid.