APPLICATION RATES:

• Apply 1 fluid ounce per 1,000 sq feet or 43.6 fl oz per acre

• For best results, apply 0.25 inches post-application irrigation when targeting soil-boren diseases (fairy ring, large patch, pythium root disfunction, summer patch, take all root rot of warm season turf and take all patch)

• Reapply every 14 to 28 days

• See the product label for full application and re-application instructions

TOLERANT TURFGRASS:

• Bentgrass
• Bermudagrass (common and hybrid)
• Bluegrass, annual (poa annua)
• Bluegrass, rough (poa trivialis)
• Buffalograss
• Centipedegrass
• Dichondra
• Fescue (fine, tall)
• Kentucky Bluegrass
• Kikuyugrass
• Paspalum, seashore
• Ryegrass (annual and perennial)
• St. Augustinegrass
• Zoysiagrass

APPLICATION INSTRUCTIONS

• Begin Pillar SC Intrinsic applications preventively (before onset or in the early stages of disease) and continue throughout the season following specified intervals and resistance management guidelines
• Make applications of Pillar SC Intrinsic under favorable turfgrass growing conditions. Application of Pillar SC Intrinsic to turfgrass under high stress is not advised.
• Use shorter specified interval and/or higher specified rate when conditions favor disease.
• Thorough and uniform coverage is required for optimal disease control.
• Application equipment must be cleaned thoroughly before and after applying this product, particularly if a product with the potential for injury was used before application of Pillar SC Intrinsic.
• Before large-scale use, apply the specified rate of Pillar SC Intrinsic on a small test area under expected growing conditions. Monitor for turfgrass injury for 14 days after application.

ENVIRONMENTAL HAZARDS

This pesticide is toxic to fish and aquatic invertebrates. Drift and runoff may be hazardous to aquatic organisms in water adjacent to treated areas. 

DO NOT apply directly to water, or to areas where surface water is present, or to intertidal areas below the mean high water mark. DO NOT contaminate water when disposing of equipment washwater or rinsate.

This product may impact surface water quality because of runoff of rainwater. This is especially true for poorly draining soils and soils with shallow groundwater.

STORAGE AND DISPOSAL

DO NOT contaminate water, food, or feed by storage or disposal.

Pesticide Storage: Store in original containers only. Keep container closed when not in use. DO NOT store near food or feed.

Pesticide Disposal: Wastes resulting from using this product may be disposed of on site or at an approved waste disposal
facility.

Container Handling: Nonrefillable Container. DO NOT reuse or refill this container. Triple rinse or pressure rinse container (or equivalent) promptly after emptying; then offer for recycling, if available, or reconditioning, if appropriate, or puncture and dispose of in a sanitary landfill, or by incineration, or by other procedures approved by state and local authorities.

Triple rinse containers small enough to shake (capacity 5 gallons) as follows: Empty the remaining contents into application equipment or a mix tank and drain for 10 seconds after the flow begins to drip. Fill the container 1/4 full with water and recap. Shake for 10 seconds. Pour rinsate into application equipment or a mix tank, or store rinsate for later use or disposal. Drain for 10 seconds after the flow begins to drip. Repeat this procedure two more times.