Remedy Ultra Herbicide mix rates vary depending on where and how you are treating. Please refer to the product label for complete information on your application. For spot treatment use a 1 to 1.5% solution of Remedy Ultra in water (1 to 1 1/2 gallons of Remedy Ultra in 100 gallons total spray mixture or 0.78 to 1.92 fl oz per gallon) and spray the entire plant to completely wet the foliage.
You can apply Remedy Ultra Herbicide on your own property for treatment but cannot on others (neighbors, friends, family, for profit etc) without a license issued by your state.
Remedy Ultra Herbicide will kill or injure all woody plants that are contacted with the spray including rose of sharon. It grows from the root and should not be treated in the heat of the summer as the leaves turn hard and become impervious. You can spray Remedy Herbicide on when they put on nice leaves for eradication. Please let us know if you need anything else.
There are no grazing restrictions except for lactating animals when using Remedy Ultra Herbicide. With lactating animals, they should be kept from grazing in the area for the growing season.
The rates for Remedy Ultra Herbicide will vary depending on where and how you are treating. Please refer to the product label for the rates for your specific needs.
Per the product label for Remedy Ultra Herbicide, for Low Volume Basal Bark Treatments:
"To control susceptible woody plants...with stems less than 6 inches in diameter, mix 20 to 30 gallons of Remedy Ultra in enough oil to make 100 gallons of spray mixture. Apply with a backpack or knapsack sprayer using low pressure and a solid cone or flat fan nozzle. Spray the basal parts of brush and tree trunks to a height of 12 to 15 inches from the ground in a manner which thoroughly wets the lower stem, including the root collar area, but not to the point of runoff."
This dilution rate would break down to 25.6 to 51.2 ounces of concentrate in enough oil to make 1 gallon of finished solution.
Remedy Ultra Herbicide is labeled for yaupon holly and should do a good job when used as directed on the product label. Hi-Yield Triclopyr Ester Ultra contains the same active ingredient at a lower cost if smaller areas need treatment.
Yes, you can use Remedy Ultra Herbicide to get rid of Chinese tallow trees. You will need to cut the trees down to the stump, and then immediately treat the stumps. You can apply this product undiluted directly to the fresh cuts.
The rates for Remedy Ultra Herbicide will vary depending on where and how you are treating. Please refer to the product label for complete instructions for your specific application. For spot treatment, you will use a 1 to 1.5% solution of Remedy Ultra in water (1 to 1 1/2 gallons of Remedy Ultra in 100 gallons total spray mixture, or 0.78 to 1.92 fl oz per gallon) and spray the entire plant to completely wet the foliage.
The best way to clean your sprayer is to triple rinse it between uses. Triple rinse means to rinse out the inside of the sprayer 3 times, and also fill it with water and run clean water through the hose for at least 1 minute to make sure that there is no residual left in the hose in addition to the tank.
You can use the Southern Ag Non-Ionic Surfactant for Herbicides with Remedy Ultra Herbicide.
Per the product label for Remedy, when treating for mesquite only, you would need to mix with Reclaim (though we do not carry this product) for best results. The rate to apply is 1/2 to 1 pint Remedy Ultra per acre in combination with 2/3 to 1 1/3 pint per acre of Reclaim. Apply with ground equiment in 10 gallons or more total volume per acre. Use a maximum of 1 gallon of oil per acre for ground application.
For cut stump treatment: Mix 20-30 gallons of Remedy Ultra in enough oil to make 100 gallons of spray mixture.
Please refer to the product label for complete instructions as further information is available for mesquite treatments on it.
The mixing ratio of Remedy Ultra Herbicide is 0.16 fl oz. per gallon of water. This is the application rate for foliar treatments. Be sure not to use more than 2 quarts per acre per year.
When using Remedy Ultra Herbicide on mesquites, you would most likely want to use it undiluted. Our recommendation is to cut them back as much as you can, and apply the product undiluted on them where you have cut them. If that is not possible, you can make cuts into the branches and stems with a hack saw and apply the product to those cuts.
Please see the attached article reference from the Texas Natural Resources on mesquites as well.
The rates for Remedy Ultra Herbicide vary depending on where and how you are treating. Please refer to the product label for complete information on your application. For spot treatment use a 1 to 1.5% solution of Remedy Ultra in water (1 to 1 1/2 gallons of Remedy Ultra in 100 gallons total spray mixture or 0.78 to 1.92 fl oz per gallon) and spray the entire plant to completely wet the foliage.
Remedy Ultra Herbicide will kill Trumpet Vine, make sure you follow the label instructions and avoid spraying or applying to desired foliage.
Remedy Ultra Herbicide can be mixed with either water or diesel fuel depending on the application.
There are no grazing restrictions except for lactating animals when using Remedy Ultra Herbicide. With lactating animals, they should be kept from grazing in the area for the growing season. The maximum amount of product that should be used per acre is 8 lbs.
The mixing ratio of Remedy Ultra Herbicide is 1.28 – 1.92 fl. oz. per gallon of water for spot treatments.
