Yes, Scotts Turf Builder Weed and Feed 3 is labeled to target Ground Ivy (aka Creeping Charlie).
When applying lime to the yard its usually done a week or two before applying a fertilizer, since the purpose of the lime is to improve soil composition and raise the pH to a level that allows the grass to uptake the nutrients better. You can still do the lime after using your Scotts Turf Builder Weed and Feed 3, and there isn't a set amount of time you would have to wait to put it down.
If Scotts Turf Builder Weed and Feed 3 is applied before seed you will need to wait at least one month to seed, sod or plant grass sprigs. If Scotts Turf Builder Weed and Feed 3 is applied after seeding you would need to delay application to newly seeded sodded or sprigged areas until the new grass has been mowed four times.
Scotts Turf Builder Weed and Feed 3 is not labeled for fairy ring. A fungicide like Heritage G would be a better option.
There is no wait time between using Scotts Turf Builder Weed and Feed 3 and Scotts Green Max Lawn Food.
There is no time restriction between applying an insecticide treatment and fertilizing your lawn. However, you should wait until the new seed has grown enough to be mowed 4 times before applying Scotts Turf Builder Weed and Feed 3 per the product label.
Scotts Turf Builder Weed and Feed 3 does state on the product label it can be reapplied after 30 days if needed.
Clover is best treated when it just emerges and using a liquid post herbicide will always give you better results than a granule that can just fall off the leaves and not contact weeds as well. Clover is also impossible to eliminate one it flowers.
After using Scotts Turf Builder Weed and Feed 3, you would want to wait at last 30 days before applying another turf builder product.
It is advisable to wait one week between applying Scotts Turf Builder Weed and Feed 3 and applying your liquid turf builder.
It is recommended not to mow within 2 days before or after application of Scotts Turf Builder Weed and Feed 3
Per the product label, it is recommended wait atleast 1 month to seed, sod or plant grass sprigs after applying Scotts Turf Builder Weed and Feed 3
Scotts Turf Builder Weed and Feed 3 should only be applied as directed to listed, established turfgrass species. You should avoid applications to landscaped areas including groundcovers.
Yes Scotts Turf Builder Weed and Feed 3 label instructions say it needs to be applied to wet grass since this product has a post-emergent herbicide in it.
To apply Scotts Turf Builder Weed and Feed 3 you can use a broadcast/rotary spreader.
The product label for Scotts Turf Builder Weed and Feed 3 just states, "Do not water your lawn for 24 hours after application or apply if rain is expected in the next 24 hours." You are safe to water the lawn anytime after 24 hours.
If Scotts Turf Builder Weed and Feed 3 is applied before seed you will need to wait at least one month to seed, sod, or plant grass sprigs. If Scotts Turf Builder Weed and Feed 3 is applied after seeding you would need to delay application to newly seeded sodded or sprigged areas until the new grass has been mowed four times.
According to the manufacturer, Scotts Turf Builder Weed and Feed 3 should be applied to moist grass, whether from morning dew or by manually sprinkling to lightly wet your lawn. You should apply when no rain is expected for 24 hours, and you should not water your lawn within that time frame after treating.
You can refer to the product label for compete application instructions, and use as directed.
Scotts Turf Builder Weed and Feed 3 states to apply to moist grass that is wet from dew or lighly irrigating before the application. Please view the full product label for more information.
