Strobe 50WG does not require watering in after application and the label states runoff of this product will be reduced by avoiding applications when rainfall or irrigation is expected to occur within 48 hours.
Depending on what fungicide you are trying to prevent by using Strobe 50WG, you will either make 2 sequential appliacations or 3 sequential applications. Pleae refer to the DIRECTIONS FOR APPLICATION FOR TURF DISEASES Table on page 11 of the product label. ?If treating for Gray leaf spot and Pythi…
Read Full Answer »We recommend waiting at least 2 days before mowing after an application of a fungicide such as Strobe 50WG.
Yes, per the product label for Strobe 50WG it can be used in a tank mix or alternation program with other registered fungicides that have a different mode of action and to which pathogen resistance has not developed. We recommend reviewing each product label for complete instructions.
Â
Strobe 50WGÂ can be applied on the ground when there is a small amount of dew.Â
The shelf life of Strobe 50WG is 3-5 years if store properly in a cool temperature stable environment and out of direct sunlight.
Strobe 50WG is mixed at 1-4 oz per 100 gallons of water. It is not suggested to apply in a hose end applicator.
The rate of Strobe 50WGÂ to use for brown patch per the product label is 0.4 oz in 2-4 gallons of water per 1000 square feet. Â Make one or two applications in fall or when conditions are favorable for disease development
Studies show that fungicides such as Strobe 50WG can work best in slightly acidic water, pH 4–6.5, so around 6 would be fine.
Application intervals for Strobe 50 WG depend on the type of turf disease you are treating for. Please review the table on pages 27-35 of the product’s label for the application intervals specific to your turf disease.
Strobe 50WG Fungicide does not control dollar spot, according to the label. You could consider using Clearys 3336F Fungicide as an alternative, which is labeled to control dollar spot.
The product label states to ensure runoff doesn’t occur following an application of Strobe 50WG Fungicide, it is best to have 48 hours before any expected rainfall or irrigation occurs. The only exception to that is if treating Spring Dead Spot as the label requires the application to be watered i…
Read Full Answer »Strobe 50WGÂ is not labeled to be used on mango or coconut.
The frequency of Strobe 50WG depends on what disease you are treating. Most application intervals range from 14-28 days. Please refer to the product label for specific application rates and intervals.Â
Strobe 50WG Fungicide should be applied at a rate of 0.2 - 0.4 oz in 1 to 2 gallons of water per 1,000 square feet. Water is just the carrier, if you are able to treat 1,000 square feet with 1 gallon of water then that will be fine. If you are unsure, we recommend calibrating your sprayer to know ho…
Read Full Answer »