VectorFog H200SF
By Craig on 11/18/2015
Be prepared to tighten all the fittings. Every nut and bolt was loose on the fogger Terrible quality control for assembly. The fogger will not start on the first try, be prepared to spend about 15 minutes repeating the start procedure, I think it takes that long to purge all the air from the fuel system. The fogger is loud so wear ear protection. The fogger will put out large amounts of fog once it runs. So far the unit works as advertised. I couldn't give it more than 3 stars because of the assembly issues.
Was this review helpful to you? YesNo
19 of 23 people found this review helpful
This is Junk
By Bik on 08/21/2020
Received this product with faulty charger. I was instructed to reach out to the manufacturer directly. The customer support mentioned I have to purchase a new charger! Are you kidding me. First of all it was a fully product that was supplied and secondly you are asking us to pay for another charger. Would never buy from you guys.
Was this review helpful to you? YesNo
5 of 5 people found this review helpful
Great fogger when it works
By Jim on 06/21/2019
H200SF Worked great the 1st use. After that it has been extremely unreliable. Backfires, spits flames, cuts out and often leaves a flame burning in the end. a few times it has run a half tank, no problem, then starts acting up again and wont work. hoping to get the manufacturer to help fix it. if not, into the dumpster. Will update.
Was this review helpful to you? YesNo
2 of 2 people found this review helpful
Great Fogger
By Matthew on 04/03/2017
Verified Purchase
