ENVIRONMENTAL HAZARDS

DO NOT apply directly to water or to areas where surface water is present. DO NOT apply to intertidal areas below the mean high watermark. DO NOT contaminate water by cleaning of equipment or disposal of equipment wash waters or rinsate.

This pesticide is toxic to vascular plants and must be used strictly in accordance with the drift and run off precautions on this label in order to minimize off-site exposures.

Under some conditions, this product may have a potential to run off to surface water or adjacent land. Where possible use methods which reduce soil erosion including no till, limited till, and contour plowing. These methods also reduce pesticide runoff. Use of vegetation filter strips along rivers creeks streams wetlands etc. or on the downhill side of fields where runoff could occur to minimize water runoff is advised.

DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

DO NOT use this product until you have read the entire label. DO NOT apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

ROTATIONAL CROP RESTRICTIONS

Rotational crop planting intervals following application of Glufosinate 24.5% Weed and Grass Killer are listed below. Failure to comply with these restrictions may result in illegal residues in rotated crops.

• Canola, Corn, Sweet Corn, Cotton, Rice, Soybean and Sugar Beet - May be planted at any time
• Root and Tuber Vegetables, Leafy Vegetables, Brassica Leafy Vegetables and Small Grains (barley, buckwheat, oats, rye, teosinte, triticale, and wheat) - 70 Days
• All Other Crops - 180 Days

APPLICATION AND MIXING PROCEDURES

DO NOT use flood jet nozzles, controlled droplet application equipment or air-assisted spray equipment. Uniform thorough spray coverage is important to achieve consistent weed control.

Ground Application: Refer to the Rate Tables for proper application rates.

Aerial Application: Poor coverage will result in reduced weed control. See the Spray Drift Management section of this label for additional information on proper application of Glufosinate 24.5% Weed and Grass Killer.

CLEANING INSTRUCTIONS

Before using Glufosinate 24.5% Weed and Grass Killer, thoroughly clean bulk storage tank, refillable tank, nurse tanks, spray tank, lines, and filter, particularly if a herbicide with the potential to injure crops was previously used. Equipment must be thoroughly rinsed using a commercial tank cleaner.

After using Glufosinate 24.5% Weed and Grass Killer, triple rinse the spray equipment and clean with a commercial tank cleaner before using for crops not labeled LibertyLink®. Make sure any rinsate or foam is thoroughly removed from spray tank and boom. Rinsate may be disposed following the pesticide disposal directions on this label.

NOZZLE SPRAY QUALITY

Glufosinate 24.5% Weed and Grass Killer is a contact herbicide and requires proper nozzles with uniform thorough spray coverage to achieve optimum weed control. See nozzle section for more detailed information.

NON-CROP USES

Glufosinate 24.5% Weed and Grass Killer controls annual and perennial weeds in non-crop areas defined below in the “Where to Apply Section”. Applications may be made on a broadcast, banded or spot treatment basis depending on the situation. Avoid direct spray or drift to desirable vegetation. Regrowth may occur due to the weed stage of growth at application, low use rate, or environmental conditions. Repeat treatments may be necessary to control plants generating from underground parts or seed.

WHEN TO APPLY

Glufosinate 24.5% Weed and Grass Killer is a foliar-active material. Best results are obtained when weeds are actively growing. Weed control may be reduced when applications are made to weeds under stress due to drought or cool temperatures. Weeds under stress or in dense populations will require application of the highest rate directed.

Glufosinate 24.5% Weed and Grass Killer must be applied at the labeled rate in the HOW TO APPLY section. Repeat applications of Glufosinate 24.5% Weed and Grass Killer or tank mixes of Glufosinate 24.5% Weed and Grass Killer plus one or more appropriate residual herbicide(s) listed on this label will be needed to control weeds emerging from underground parts or seeds.

Broadleaf Weeds

• Chickweed
• Clover
• Common Cocklebur
• Filaree
• Jimsonweed
• Kochia
• London rocket
• Malva (little mallow)
• Marestail
• Purslane
• Shepherds purse
• Smartweed

Grasses and Sedges

• Barnyardgrass
• Cupgrass
• Fall Panicum
• Giant Foxtail
• Goosegrass
• Green Foxtail
• Johnsongrass (rhizome)
• Lovegrass
• Shattercane
• Smallflower Alexandergrass (Signalgrass)
• Stinkgrass
• Windgrass
• Yellow Foxtail

*See label for the complete application instruction.