Talstar P has a residual of 30 days outdoors and 90 days indoors. If outdoors, you would need to wait 30 days to apply Alpine WSG.
Alpine WSG is used at 10 g per gallon of water and applied with a spray as directed. It cannot be fogged.
For more information on treating this species, please click the link below.
How to Get Rid of Pharaoh Ants
It is not recommended to mix borax with Alpine WSG. It should be mixed with water and applied to listed areas. We recommend that you treat the raw wood with Bora-Care.
According to the label, Alpine WSG cannot be applied to the mattress. Keep in mind that the label is the law. If you'd like something safe to spray over the mattress, you can use something like Steri-Fab.
For more information you can contact the manufacturer, BASF, at 1-800-526-1072
You can find a diagram here that shows where to apply Alpine WSG. It is recommended to use a 1-gallon pump sprater to apply this product.
Yes, Alpine WSG can be used in a PAS per the product label.
Alpine WSG is not specifically labeled for scorpions. There are other great products like Demand CS and Onslaught FastCap to treat for scorpions. Please take a moment to read over our How To Get Rid of Scorpions Guide.
Alpine WSG https://www.domyown.com/alpine-wsg-p-2876.html has a residual of 30-60 days so retreatment may be done after 30 days. How long it takes to kill insects depends on a few factors such as age and health of the insect, how long they spend on the treated surface and how soon after application they contact it. How long it takes to eliminate a roach infestation depends on how large the infestation is, how consistent and thorough you are being with treatments and what products you are using. There is not a set time; it can take but it can take weeks or months even to get complete control. Alpine WSG is typically not used alone but in combination with other products. We would recommend one of our roach control kits. You can see the kits by clicking on the link here. We also have a great article for eliminating them that can offer some great advice; you can find it here.
A single pack of Alpine WSG is applied to a gallon of water per 1,000 sq ft.
Alpine WSG and Temprid FX contain different active ingredients. Alpine WSG is water soluble granule whereas Temprix FX is a liquid concentrate. They are both labeled for cockroaches (as a portion of the treatment of this pest) if used as directed to listed areas. We do offer the Temprid FX in our Roach Control Kits here. For a successful roach control program, please check out our article here.
Alpine WSG is not labeled for emerald ash borers in this particular formulation. We do have other products with a different active ingredient in it that can be used for a basal trunk treatment, such as Adonis 2F Insecticide. Be sure to check the label on the specifics on how much should be used per gallon of water.
Alpine WSG does not contain sulfur per product label.
Alpine WSG can take a few weeks to decrease the insect population..
Alpine WSG is a water soluable granule which must be dissolved in water and sprayed. It can not be applied as a granular broadcast application.
Alpine WSG can be purchased 24/7 on our site, or you can call and place your order with one of our associates by calling 1-866-581-7378 M-F 9am-5pm EST.
You can use 10-30g of Apline WSG per gallon of water depending on which pest(s) you are treating. Please refer to the product label for complete application instructions. NyGuard IGR is mixed at 3ml per gallon of water so you would need have the rate of each for the ½ gallon container of water used for application