Coron 18-3-6 Plus 0.5% Fe should not be used in temperatures above 80 degrees Fahrenheit and below 50 degrees Fahrenheit. Be sure to apply in the early morning or late evening hours to avoid the heat of the day in the summer months.
CoRoN 18-3-6 Plus 0.5% Fe can be applied at any time as long as the turf is not dormant. The healthiest, hardiest lawns are fertilized 4 times per year - in the fall, summer, early spring, and late spring, using fertilizers dependent upon what nutrients your lawn needs throughout the year.
Yes, a surfactant such as Duo Stick would be recommended to use when applying a mixed solution of CoRoN 18-3-6 Plus 0.5% Fe and Drive XLR8 to increase the effectiveness of the active ingredient quinclorac in Drive XLR8.
CoRoN 18-3-6 Plus 0.5% Fe if stored in a cool dry area without freezing will last for approx. 2 years.
Yes, the CoRon 18-3-6 Plus 0.5% Fe will stain the concrete if sprayed on it. The dye in the product will stain any porous surface.
CoRoN is compatible with most fungicides, herbicides and insecticides so should be ok to mix with Trimec Classic and Cy-Kick CS. Be sure to follow each product labels instructions for rates and coverage area and further instructions regarding tank mixing.
CoRoN 18-3-6 Plus 0.5% Fe can be mixed with Prodiamine 65 WDG and applied at the same time as long as they stay mixed in the tank.
Per the CoRoN 18-3-6 Plus 0.5% Fe product label: For cool season grasses you should be using 3.75-4.25 lbs of nitrogen per 1000 sq/ft per year. Many customers break down their fertilizer applications into 6-8 applications per year throughout the growing season. If we go with 6 times a year and a desired rate of 4 lbs of nitrogen per 1000 sq/ft per year, you would be looking at roughly 45 oz per 1000 sq/ft per each of the 6 applications. If you only have 200 sq/ft of lawn to treat then you would only need roughly 9 oz to that area in likely ½ -¾ gallon of water at most. You typically use 1-2 gallons of water per 1000 sq/ft, so since your area is much smaller than that you should not be using that high of a water volume.
Usually, a fertillizer such as CoRoN 18-3-6 Plus 0.5% Fe can be applied at any time as long as the turf is not dormant.
CoRoN 18-3-6 Plus 0.5% Fe can burn if too much is applied or if applied to heat/drought stressed lawns. It should not be used in temperatures above 80 degrees Fahrenheit and below 50 degrees Fahrenheit. Be sure to apply in the early morning or late evening hours to avoid the heat of the day in the summer months.
CoRoN 18-3-6 Plus 0.5% Fe can be applied with the Chapin Wet/Dry Hose-End sprayer. The mixing ratio for CoRon 18-3-6 Plus 0.5% Fe for most applications is 22 oz. per 1000 sq. ft. To calculate the Chapin Liquid Hose End Sprayer settings, please see the following instructions:
Instructions For The Liquid Side:
The liquid side must always be used with a straw/diptube as this is a powerful and very accurate venturi system which draws liquid product through a small opening and mixes it with the water passing through.
YOU MUST HAVE A STRAW WHEN USING LIQUID PRODUCTS.
There are four selections:
This means when you are out of product in the jar, you have sprayed the total liters/gallon of mixed product you have selected.
CoRoN 18-3-6 Plus 0.5% Fe could be applied after a rain as long as the ground is no soaked. You will still need to use a sufficient amount of water with CoRoN 18-3-6 Plus 0.5% Fe to cover the area being treated.