Drexel F. M. 160 Foam Marker Concentrate

FEATURES AND BENEFITS:

• Produces a dense, readily visible, white foam
• Can be used for marking applications of pesticide, fertilizers, seed planting and general cultivation
• Works in a range of conditions, including water hardness and humidity
• Temperature stable formulation

MIXING INSTRUCTIONS:

 Fill foam generator one-fourth full with water and add the required amount of this product. Add enough water to fill foam generator to one-half full. Do not fill above one-half full as this may impair the operation of the foam generator.

The ideal foam consists of small tight cells and is not so dry as to blow away or so wet that it has no body. Reduce air pressure if foam is wet and is coming out as a creamy liquid. Use less of this product per unit volume of water or increase air pressure if foam is too dry. Foam droppings of 3 to 5 inches in diameter are recommended for better visibility and longer stability.

DIRECTIONS FOR USE:

To produce a good quality foam, be certain to flush and clean the foam generating equipment thoroughly before each use.

Apply this product at a rate of 1 gallon per 160 gallons of water. This dilution rate will produce an adequate amount of foam from most types of foam generating equipment. The best dilution rate depends on water hardness, equipment, and required foam persistence.

Note: Foam life will vary with water hardness, humidity, temperature, and soil moisture content.

ENVIRONMENTAL HAZARDS:

Do not contaminate water sources by cleaning of equipment or disposal of washwater.

FREQUENTLY ASKED QUESTIONS:

Will F.M. - 160 provide sufficient longevity of foam under high temperatures?

• F.M.-160 is tested thoroughly in the lab and in field situations and has been established as a foam of choice by many users.

How does hard water affect foaming ability of F.M.-160?

• Under hard water conditions, it may be necessary to use 1 gallon of F.M.-160 per 80 gallons of water.