FastOut CS Foam is the only microencapsulated, ready-to-use insecticide foam with non-repellent residual activity.  Non-repellant means that insects will pass right through the foam or the residual without detecting the insecticide. FastOut CS comes with a broad label that controls termites and 34 other common insect pests. In addition, the product is labeled for food-handling areas and commercial kitchens. FastOut CS delivers an expansive dry foam very quickly and easily, allowing you to fill cracks, crevices and voids, such as wall voids, or the voids in freestanding kitchen equipment (which often harbor pests). The foam stays where it is applied, without running off surfaces like liquid insecticides do, allowing you to treat the exact areas you want.


Note about treating Termites:

FastOut™ CS Foam cannot be used as a sole source for the control of active structural infestations of subterranean termites and is intended as a support tool to soil residual insecticides, termite bait systems, or other products that are registered and labeled as sole source or stand-alone termite control products. This treatment is intended for localized termite infestations only. The purpose of such applications of FastOut™ CS Foam is to kill workers or winged reproductive forms which may be present in the treated channels at the time of treatment. Such applications are not a substitute for mechanical alteration, soil treatment or foundation treatment but are merely a supplement.


How to Use:

Always read the product label before use.

FastOut CS Foam brings all the advantages of SmartCapTM microencapsulation  Technology in a convenient can to reach tough voids. As the foam is applied, it expands,
spreading microcapsules throughout the void, coating insects and all internal
void surfaces for complete coverage and long-lasting control. Equipped
with an extremely versatile label, this product fills a niche that others
don’t address. Whether it’s a wood destroying insect job or general pest,
commercial kitchen or private residence, this ready-to-use product is good to
have at your side.

1. Shake Well
Shake container for several seconds before each use. This helps to activate
the foaming agents for optimal foam consistency and smooth delivery.

2. Drill Hole (if necessary)
It may be necessary to create access into a void for treatment (such as a wall void). Drill a hole using a 1/8" drill bit for best fit with the injector tip.

3. Apply Treatment
Insert the injector tip tightly into access hole of void and depress actuator. FastOut CS Foam delivers foam at a rate of approximately 1 quart (fully expanded) per 10 seconds.

4. Wait 8 Seconds
After applying the appropriate amount of FastOut CS Foam, release the actuator but continue to hold the injector tip tightly in the access hole. Wait at least 8 seconds while the product within the injector tube fully expands and dispenses into the treatment area.




(images by Whitmire Micro-Gen)