Santa Fe Compact 2 Pump Kit (4030113)

Santa Fe Compact 2 Pump Kit (4030113)
Santa Fe Compact 2 Pump Kit (4030113)

Ask A Pro

Call Us: 866-581-7378
Mon-Fri 9am-5pm ET
Email Customer Service
For help with your order
Live Chat
DIY Pros Available Now

You May Also Need

Santa Fe Compact70 Dehumidifier
$1,119.00
Temprid FX 8 mL
$9.98

Average Rating

There are no reviews for this product yet. Be the first.

Product Overview

Santa Fe Compact 2 Pump Kit is an add-on to the Compact 2 dehumidifiers. This kit is a great addition when you need to move the water, collected by the dehumidifier, to go higher than the unit. Capable of going 15 feet high, the tube is 20 foot long so the water can reach areas that it normally would not with just the unit. The pump itself can be attached to the dehumidifier with the brackets that come with the kit. This kit has a 1 year warranty from the manufacturer.

Features and Specs

For use in: Indoor residential areas.
Shipping Weight: 7.00 lbs
Manufacturer: Santa Fe Dehumidifiers (Mfg. Number: 4030113)

Details

INSTALLATION INSTRUCTIONS

Step 1. Elevate unit 6" in height.
Note: Feet can only provide 2 1/2" height. Extra lift to be provided by installer. CAUTION! The pump and bracket are not designed to support the weight of the unit. Do not allow the unit to rest on the pump and mounting bracket after it is installed.

Step 2. Knock inlet hole out of the condensate pump in the location shown. (For pictures, refer to the product label linked on this page.) 

Step 3. Using a screwdriver, remove two screws located on the side of the unit as shown.

Step 4. Attach the condensate pump assembly using the two screws as shown. Do not over tighten the screws.

Step 5. Attach the hoses as shown. Install the smaller (3/8") drain hose onto the barbed outlet fitting of the condensate pump. Verify hose is secured tightly to condensate pump by pulling gently on hose. Route hose appropriately to a drain.
Note: Do not exceed 10 ft. vertically when pumping to a drain above the unit. Using the original (5/8") product hose, cut to approximately 6" in length and route to the condensate pump as shown. Insert hose half way into the condensate pump. Do not push hose to the bottom of the condensate pump.

Step 6. Plug the pump and dehumidifier cords into an outlet that is protected with a GFCI device on its circuit.

There are no reviews for this product yet. Be the first.

Questions & Answers

Have a question about this product?

There are no questions for this product yet. Ask the first.