PRODUCT DIRECTIONS

READ ENTIRE LABEL. USE STRICTLY IN ACCORDANCE WITH PRECAUTIONARY STATEMENTS AND DIRECTIONS, AND WITH APPLICABLE STATE AND FEDERAL REGULATIONS.

Chemigation:

Application through Irrigation Systems (Chemigation):

Apply through irrigation to crops at rates and timings specified in this label. Chemical tank and injector system must be thoroughly cleaned before and after use. Flush system with clean water.

Drip Irrigation: Use for control of soilborne diseases at rates and timing as specified in this label. Ensure adequate soil moisture prior to utilizing in a drip irrigation system. Do not apply through drip irrigation that is deeper than 12" below the soil surface.

Discontinue drip irrigation application at fungicide depletion from the main feed supply tank or after 6 hours from start, whichever is shorter. Delay subsequent irrigation (water only) for at least 24 hours following drip application for best results.

Sprinkler Irrigation: Apply this product through sprinkler irrigation systems including center pivot, lateral move, end tow, side (wheel) roll, traveler, big gun, solid set, micro sprinkler or hand move irrigation systems. Do not apply this product through any other type of irrigation system except as specified on this label.

With Center Pivot irrigation equipment, use only with equipment with drive systems that provide uniform water distribution. Do not use end guns for chemigation due to the non-uniform application pattern.

Add to the pesticide supply tank containing sufficient water to maintain a continuous flow by the injection equipment. Maintain agitation during the entire application period.

For continuous-move irrigation systems, apply the labeled rate for that crop in 1/2 acre-inch or less per acre. For stationary or non-continuous moving systems, inject spray mixture during the last 20-30 minutes of the set.

Do not apply when winds are greater than 10-15 mph to avoid drift or wind skips. Do not apply when wind speed favors drift beyond the area intended for treatment. Crop injury, lack of effectiveness, or illegal pesticide residues in the crop can result from non-uniform distribution of treated water. Thorough coverage of foliage is required for good control.

If you have questions about calibration you should contact a State Extension Service specialist, equipment manufacturer or other experts.

CROP USE DIRECTIONS

CORN

• Gray Leaf Spot, Southern Corn Leaf Blight, Northern Corn Leaf Blight, Rust, Southern Rust, Eyespot, Anthracnose leaf blight, Northern Corn Leaf Spot
  • 7 to 14 fl. oz./A
  • Apply preventively or when conditions are favorable for disease development. One repeat application may be made.
  • Apply no later than growth stage R4 (early dough stage).
  • For aerial application, use a minimum of 2 gallons of spray solution per acre.
  • 7 days interval

COTTON

• Alternaria leaf spot, boll rot, anthracnose, Ascochyta blight, Cercospora blight, and leaf spot, Diplodia boll rot, Fusarium boll rot, Phoma blight, rust, Stemphyllium leaf spot, target spot
  • 7 to 14 fl. oz./A
  • Apply preventively or when conditions are favorable for disease development. Repeat as necessary if conditions are favorable for disease development.
  • 7 days interval

*See label for the complete list of crops, diseases, directions, and application rates.