Aim EC Herbicide is specially formulated to solve every broadleaf weed problems. Contains an active ingredient that helps in controlling unwanted broadleaf weeds. It comes in an emulsifiable concentrate formulation, making it easy to apply and convenient to use. Aim EC Herbicide is a powerful non-residual herbicide that can eliminate even the toughest broadleaf weeds including pigweed, morning glory, velvetleaf, seedling Kochia, and Lambsquarters. Proven to be cost-saving because it offers a low use rate plus, is fast-acting because it shows signs of desiccation of susceptible weeds a few hours after the application. This post-emergent herbicide controls broadleaf weeds in crops such as sunflowers, corn, rice, cotton, and nut crops. For best results, avoid applying within 6 to 8 hours of rain or irrigation.
AIM EC may be tank-mixed with other registered herbicides for controlling a broader spectrum of weeds. Refer to this and other product's labels for mixing instructions, precautions, and restrictions. Follow the most restrictive instructions for each tank mix partner. When preparing a new tank mix, conduct an appropriate compatibility test by mixing proportional amounts of all spray ingredients in a test vessel (jar) prior to tank mixing with other products. Shake the mixture vigorously and allow it to stand for five to ten minutes. Rapid precipitation of the ingredients and failure to re-suspend when shaken indicates that the mixture is incompatible and should not be applied. Provided the jar test indicates the mixture to be compatible, prepare the tank mixture as follows: Fill the tank one-fourth full with water. With the agitator operating, add the recommended amounts of ingredients using the following order: dry granules first and liquid suspensions (flowable) second. As the agitation continues and the tank is filled with water and emulsifiable concentrate products third followed by the addition of water-soluble products.
Mixing and Loading Instructions:
Start by filling the tank with 3/4 of the desired volume of clean water and, with agitation, add the proper amount of AIM EC. Complete filling the spray tank to the desired volume. Maintain sufficient agitation to keep materials in solution during both mixing and application and until the spray tank has been emptied. For tank mixtures, follow your local extension guidelines for mixing order. General guidelines are: Add dry materials first and agitate until mixed; then EW or water-soluble liquids; then EC formulations; then, add adjuvants last. Ensure the compatibility of other products and/or liquid fertilizers with AIM EC before mixing them together in the spray tank.