Demand CS Insecticide - Questions & Answers

Yes, Demand CS is labeled for Japanese beetles and can be applied to rose bushes (do not apply directly to blooms).  

Per the product label all people and pets should be kept out of the treated area until the treated area dries. Please contact the manufacturer Syngenta at 866-796-4368, as well as your pets Vet.

We do not carry Black Flag Foggers and so we cannot make an accurate recommendation. We can say that in the foggers we do carry, the Demand CS particles are too large and have the potential to clog the fogger.

Demand CS is a great general pest control and works well for spiders, earwigs, ants, mosquitoes and many others. It should be applied monthly outside and inside quarterly. It would be safe if to apply when the dogs are not present until the surfaces are completely dry. 

Insecticides should not be exposed to extreme temperatures such as freezing or over heating or left for prolonged periods of time in direct sunlight. In the case of Demand CS, as long it was only frozen for a very short period of time and after it was thawed out it went back into a solution (the way it usually looks) it should be fine to use. If however it appears that there are particles floating at the top, the product now appears discolored, or the product will not go back into a solution, the product should be discarded and replaced.

Demand CS is not specifically labeled for springtails but the Demand G Granules are labeled for springtail control .Please take a look at our Springtail Control Guide for helpful tips for springtail control and product recommendations. 

Demand CS and Exciter can be mixed together for mosquito control for use in a pump sprayer. Demand CS is not labeled for use inside of a fogger.

According to the Demand CS product label, delay watering or mowing for 12–24 hours for optimum control of surface-feeding insect pests. 

There is only Demand CS, we are not aware of a Demand SC product.  One of our roach control kits would be more recommended for roach control. These professional kits includes non-staining, low odor concentrated insecticide for spraying the outside perimeter of the home and inside underneath appliances, behind cabinets, under toilets and sinks, etc. You'll also get Roach Bait Gel to help get rid of those roaches that like to hide. Baits can be applied up high in the kitchen in the corner of cabinets and in cracks and crevices in kitchens and bathrooms. The bait contains a slow-acting poison that attracts and kills feeding roaches, who also spread the bait to other roaches by contact or by sharing food. Finally, an Insect Growth Regulator is offered which will stop roaches from laying eggs, helping to halt the infestation. The combination of an IGR with roach bait is a highly effective roach control strategy that is widely used by pest control professionals. The insecticide must be applied with a 1 gallon pump sprayer.

Here is a link to a great article that really goes into depth in explaining a roach control program:

http://www.domyownpestcontrol.com/how-to-get-rid-of-roaches-a-458.html

Yes, you can apply Demand CS on and around bushes and shrubs and on grass. In fact you want to spray around the outside perimeter 2-3 feet up and out. Indoors you want to spray cracks, crevices, baseboards. It will not stain should a small amount land on carpeting.

Demand CS dries clear and leaves no visible residual when used as directed on the product label.  

You should wait to apply Demand CS on a day when rain is not expected. The product cannot adhere to wet surfaces and rain would wash it away if the application had not had a chance to dry before the rain came.

The manufacturer recommends that you use a buffering agent when the pH is not between 5-7 per the product label instructions when applying Demand CS.

When using Demand CS it can take minutes to hours to kill scorpions. The active ingredient needs time to work through the follicle of the insect to the central nervous system.

Demand CS should be used within 24 hours of mixing the solution. After that the product starts to lose its effectiveness. 

Talstar (and we hope they are adding an insect growth regulator such as Archer IGR to the product mix you mentioned) should do a great job for you. If you wanted to use something with a little more strength you could try Demand CS or its generic Equil Lambda CS. These products contain lambda-cyhalothrin and they are micro-encapsulated which makes them last a little longer on outdoor surfaces. You should remember that ticks may be hidden in tall or dense brush so higher treatment volumes may be needed to treat the entire plant, not just the top side of the plant where it is easiest to spray. You should try to get the application on the underside of leaves and all the way to the bottom of the plant. When you are dealing with an area that has a high tick population you may be required to treat once a month from spring through to the first frost, no matter what product you use. The problem on your property may be that ticks are being reintroduced into the area on a consistent basis by wildlife such as deer, raccoons or birds. You will be required to use non-chemical means to reduce the tick population in addition to insecticides. As with most pests you can modify the environment on your property to make it less favorable to ticks. Keeping grass and weeds cut short in tick infested areas increases tick death during hot weather, discourages wildlife and will reduce the amount of vegetation which may need a pesticide application to kill ticks. Clear away yard debris such as old firewood or leaf piles. Remove old or abandoned bird nests and rodent nests. Patch fences where wildlife may be gaining access to your property. It may also be helpful to have the ticks identified. By identifying the type of ticks you can better understand what type of animals may be bringing them to your property and you can modify the environment to make it less favorable for that host animal. You can contact your local cooperative extension office to request an insect identification.

Usually, the only effect someone would have from coming into direct contact with Demand CS concentrate would be a minor skin irritation. For more information please contact Sygenta, the manufacturer of Demand CS at 866-796-4368

First, you need to determine how many gallons of water you will be using. To find out how many gallons of water you need to use you will calculate the square footage of the area to be treated(Dmeand CS recommend 1 gallon of mixed solution 1,000 sq feet). For instance, if you have a 6,000 square foot yard that you plan on treating then you would need to multiply 6 x 0.8 which equals 4.8 – You would then add 4.8 oz of Demand CS to the reservoir. Once you add the desired amount of Demand CS to the reservoir, then you would add water to the line selected (6 gallon line mark on the reservoir). You would then set the dial on the top of the Chapin Hose End Sprayer to 6 gallons. Do not turn water on when adjusting the spray nozzle. Next, select the desired spray pattern and then spray until the reservoir is empty.

If you mix Demand CS at the 0.3% ratio, it will make 32 gallons if you have the 8 oz bottle and 128 gallons of mixed solution if you have the 32 oz bottle. You will mix 0.4 oz (12 ml) of Demand CS per gallon of water.

You can use Demand CS is in the attic to help control the stinkbugs. Only the stinkbugs that come in contact with treated areas will be killed. We mention this because many of these pests will remain hidden and will not come out until it really starts to warm up so you may have pretty mixed results.