Monterey Consan 20 is a fungicide, disinfectant and deodorizer in one. This multi-purpose liquid formulation effectively cleans and disinfects hard surfaces in homes, ornamentals, lawns, greenhouses, walkways, birdbaths, foundations and gardens while helping control molds, mildews, algae and other plant diseases. It is effective in controlling brown patch on lawns, black spots on roses, algae on garden surfaces, among others. It features a highly-concentrated formula which lets you use low rates for a wide range of uses. It is biodegradable.
Treatment is restricted to indoor uses or uses in which controlled conditions to prevent runoff and exposure to the environment. In the case of diseased trees, the spot treatment of trees must be at least 100 feet from any pond, lake, stream, or river to prevent possible runoff of the product into the waterway. DO NOT APPLY BY AERIAL SPRAY.
GENERAL DISINFECTION PERFORMANCE IN NON-MEDICAL FACILITIES:
At 1.5 ounces of this product per 5 gallons of water use level (or equivalent use dilution) (469 ppm active) and with a 10-minute contact time, this product) is bactericidal according to the AOAC Use Dilution Test method on hard, non-porous surfaces modified in the presence of 5% organic serum against: Campylobacter jejuni, Escherichia coli 0157:H7, Listeria monocytogenes, Proteus mirabilis, Salmonella enterica, Staphylococcus aureus, Staphylococcus aureus Methicillin resistant, Yersinia enterocolitica.
At 2 ounces of this product per 5 gallons of water use level (or equivalent use dilution) (625 ppm active) and with a 10-minute contact time, this product is effective in the presence of 5% blood serum against the following on hard non-porous surfaces: Trichophyton mentagrophytes, Aspergillus niger.
HORTICULTURAL AND ORNAMENTAL PLANT
MONTEREY CONSAN 20 is a general disinfectant. It will help in the control of fungal, bacterial and viral plant pathogens, bacterial and fungal leaf rots, slime forming fungi, and odor causing bacteria and algae. It is designed specifically for use where disease cross contamination may occur between plants. Pre-clean all surfaces prior to application of the disinfectant solution. All inanimate surfaces must be thoroughly wetted and remain wet for 10 minutes for disinfection. Then wipe up excess or allow to air dry. Fresh solution must be prepared daily and when use solution becomes visibly dirty. To apply solution for sprayer applications, use as a coarse spray only.
Can Monterey Consan 20 be used to kill mold on Sheetrock?
The manufacturer does not recommend that you use the Monterey Consan 20 on sheetrock. Sheetrock retains a lot of moisture, so the better solution would be to remove the sheetrock and insulation, treat the wood studs in the wall with Bora-Care with MoldCare, and then replace the insulation and sheetrock. Please look at the regular Bora Care with Mold Care which will kill and prevent future mold growth on a variety of surfaces including wood, cellulosic drywall (sheetrock), and concrete. You may paint surfaces after you have treated with Bora Care with Mold Care and allowed it to fully dry which should take about 72 hours.
Can I use Monterey Consan 20 to spray on attic insulation where roof rats have deficated?
No Monterey Consan 20 would not be used in an attic. Nisus DSV can be used in attics and almost any area to clean up rodent or any other pest droppings and will not harm insulation, wood or other materials within the attic or treatment areas. If possible though it would be best to replace the insulation.