Concrete areas should be drilled and apply Taurus SC Termiticide every 10-12" apart, 2" from the foundation. You will disperse 4 gallons every 10 ft of drilled holes. Please take a few moments to review our treatment article on How to Get Rid of Termites for a successful application.
Taurus SC is not for indoor use at all unless you are treating for an active termite colony behind a wall void that you plan to drill a small hole into the wall to get to. If that is the case, you would use the same rate as you would for the trenching method outdoors which is 0.8 oz per gallon of water.
Yes, you can inject Taurus SC under the slab that is part of the house area. This would be considered part of your termite treatment since they were found active in this area. You would NOT be permitted to apply the Taurus SC to the new wood that is being installed. The best product for this application would be Boracare which is a wood preservative that can be applied to any raw wood and lasts for the life of the wood.
You would use a funnel or set your sprayer to a pin stream setting to apply ½ gallon of Taurus SC Termiticide finished solution in each drilled hole in concrete. You do not have to replace the wood unless it is extremely damaged, but you will need to also spray Taurus into the wood where the termites are actively infesting to spot treat it.
If you are using Taurus SC Termiticide for termite prevention, yes it must be applied in a trench as explained in our guide here as well as on the product label. For just general pests it can be sprayed around the perimeter of the home 1 to 2 feet up and out on the ground but this not effect termites that do not contact the surface. When termites forage they are inches below the soil
Taurus SC Termiticide does list tree treatments on the label. However, it is only labeled for injection applications, and not for a general spray on or around trees.
When you have any concrete against the home (such as a patio or garage that shares walls with inside rooms) that prevents you from trenching across it, you have to drill holes every 12 inches and treat each hole with roughly 1/2 to 1 gallon of mixed solution. Each hole should be drilled with a bit that is roughly 1/2 wide and 18 inches long. Please review the Taurus SC Product Label and our article How To Do A Termite Treatment for all the proper techniques for a homeowner to treat this area.
Taurus SC Termiticide is a liquid concentrate that is diluted with water and applied as directed on the product label.
Taurus SC Termiticide has a long residual and should only be applied at the lowest rate if using 4 times a year as labeled by the manufacturer to be the safest application. You will still see ants after application as it takes time to completely kill off a colony but you should not apply more often than labeled. They will still die after contacting a treated area.
Taurus SC Termiticide is not labeled to be applied on plants at all. It should only be applied 1 ft up and 1 ft out topically to the exterior of a structure or in trenched, rodded or drilled holes for a termite application. Please refer to the product label for complete application and mixing instructions.
When trenching with Taurus SC Termiticide, you should dig a 6" wide by 6" deep trench directly against the foundation of the exterior walls. Be sure to read our Liquid Termite Treatment article for full directions.
Taurus SC is NOT labeled for mites or indoor applications. We do not contain a fipronil product that is labeled for this type of application indoors or for the specific insect that you are treating. We highly recommend that you contact your local cooperative extension office for a product selection that will best fit your needs with this particular active ingredient.
Taurus SC Termiticide would be a very effective product to use for ant control outdoors. This insecticide can be used as an outdoor perimeter treatment around your homes foundation. It puts a barrier down and keeps the ants from being able to infest your home. It has a 6 month residual and will not only work for ants, but a number of other insects as well.
There is currently no known resistance issue with Taurus SC Termiticide. It is a slow kill that kills off entire colonies so there should be none left to carry on a resistance, but it can take years of exposure to the same product to develop any type. An alternative product would be Phantom which can also be used inside along baseboards and in cracks and crevices where Taurus cannot be used.
No, Taurus SC is not labeled for springtails. We would recommend using Talstar P around your home for springtails. This product should not be sprayed in the same areas as Taurus SC so that they do not work against each other. The mixing ratio is 1 fl. oz. per gallon of water. When treating for springtails, it is crucial to identify and eliminate the excess moisture issue where this pest breeds in order to permantly address the infestation.
There is no need to reapply Taurus SC Termiticide if rainfall occured 14 hours after treatment. That is plenty of time for the product to become rainfast.
Both Taurus SC and Tandem Insecticide are great products and very effective. Keep in mind that Taurus is labeled for outdoor use only, whereas Tandem can be used inside and outside.
Taurus SC Termiticide should NOT be used on pets or used to treat fleas inside or outside the home. It is an exterior product for treating termites and other listed pests/applications against the structure. We do offer products for Indoor, Outdoor and Pet Flea Control. Please take a few moments to review our treatment article on How to Get Rid of Fleas for a successful eradication program.
