GROWING CROPS (OUTDOORS AND IN GREENHOUSES):

Apply 2 to 16 fluid ounces per acre (147 ml to 1,182 ml/Ha) and repeat if required to maintain effective kill. Use in sufficient water for thorough coverage of upper and lower leaf surfaces unless otherwise noted. This may be applied by air in no less than 2 gallons of water per acre (3,02 L/Ha) and by ground in no less than 10 gallons of water per acre (15.12 L/Ha). It is recommended that the final spray mix be buffered to a pH of 5.5-7.0.

This concentrate is relatively non-toxic to honey bees. To avoid possible harm to honey bees, it is advisable to apply in the early morning or late evening hours.

Evergreen Crop Protection EC 60-6 may be used on most crops because its active ingredients are exempt from tolerances when applied to growing crops. The crop-grouping scheme used on this label was devised by the Environmental Protection Agency to expedite minor use pesticide registration.

Best Practices

• pH of spray should be between 5.5 and 7.0
• As a contact insecticide adequate spray coverage is essential
• Can be applied with a wetting agent, spreader, or surfactant
• Begin at middle application rate of 8 oz. per acre unless:
  • Insect populations are very high
  • Insects are in late-stage immaturity or are adults
• EverGreen provides rapid knockdown and kill, and resistance management benefits to insecticides and acaracides when tank mixed
• Use as a clean up or pre-harvest spray
• Night time, late evening, and early morning are best times to apply
• Most effective when applied to insects at early stages of life
• Best applied when insects are active
• Apply when beneficial insects are not present
• Always follow label directions and SDS