GameOn Herbicide

Directions for Use

GameOn is recommended for use on the following turfgrass species:

• bentgrass
• bluegrass, Kentucky
• fescue, chewing
• fescue, creeping red
• fescue, sheeps
• fescue, tall
• fescue, hard
• ryegrass, perennial

Established Warm Season Turfgrass

• bermudagrass
• fescue, tall (growing in warm-season areas)
• zoysiagrass

GameOn may discolor and/or stunt turfgrass that is not well established or is stressed or weakened due to unfavorable climatic conditions, temperature extremes, drought, nematodes, or other factors which damage or weaken turf. Apply GameOn only to healthy, well-established turfgrass that has a well-anchored root system.

Treatment on Turfgrass Species Not Listed on the Label for GameOn

Users who wish to use GameOn on turfgrass species not listed on this label may determine the suitability for use by treating a small area at a specified rate. Prior to treatment of larger areas, observe the treated area for any sign of herbicidal injury during 40 days of normal growing conditions to determine if the target turfgrass species is tolerant. The user assumes responsibility for any plant damage or other liability resulting from use of GameOn on turfgrass species not listed on this label.

USE SITES

Turfgrass Excluding Turfgrass Grown for Sod Farms

Application Timing and Rates

Best weed control results are obtained when GameOn is applied to small, actively growing weeds. Extreme growing conditions such as drought or near-freezing temperatures prior to, at, or following the time of application may reduce weed control.

Apply GameOn to newly seeded or sprigged turfgrass only after the second mowing or after the turfgrass seedlings have tillered and developed an adequate secondary root system. Reseeding is not recommended for at least three weeks after application.

Apply GameOn to turfgrass at the rate of 3 to 4 pints per acre as a ground broadcast treatment or spot treatment. Use higher rates from 3.5 to 4 pints per acre for weeds that are more mature or difficult to control. Calibrate application equipment prior to use according to manufacturer’s directions. Avoid skips or overlaps as poor weed control or plant injury may occur.

Spray Coverage

Use sufficient spray volume to provide thorough coverage and a uniform spray pattern. Do not broadcast apply in less than 10 gallons of total spray volume per acre. For best results and to minimize spray drift, apply in a spray volume of 10 gallons or more per acre. As turfgrass canopy and weed density increase, increase spray volume to obtain optimum weed control. Use only nozzle types and spray equipment designed for herbicide application. To reduce spray drift, follow precautions under Spray Drift Management.

Spot Treatment of Ornamental Turfgrass Using Portable Sprayers

Mix 1.3 fl oz of GameOn in enough water to make 1 gallon of spray and apply at any time broadleaf weeds are susceptible by wetting foliage of undesirable plants to point of runoff. This is enough spray to treat approximately 1000 sq ft of turf.

Turfgrass Grown for Sod Farms

Agricultural Use Requirements: When used in sod farms, follow PPE and reentry instructions in the Agricultural Use Requirements section of this label.

• sod farms (postemergence)
  • 3 - 4 pint/acre
  • Apply 3 to 4 pints of GameOn per acre to control broadleaf weeds in turfgrass listed above except as noted in the Restrictions of this section. Deep-rooted perennials such as bindweed and Canada thistle may require repeat applications.
  • Avoid mowing sod farms for 1 to 2 days before or after application.
  • Delay irrigation until the day following application.

*See label for the complete list of weeds controlled and application rates.