The label states for high algae growth you should use between 2 and 10 Tablespoons per 1000 gallons of water. On the first treatment you would probably want to use the 10 tablespoons per 1000 gallons of water if growth is high. The label just says to re-treat as needed, just do not re-tr…
Read Full Answer »
GreenClean Pro Algaecide can be used in ponds where fish live as long as the product label is followed.
GreenClean Pro Algaecide works best when applied when temps are between 65-75 degrees.
Per the manufacturer GreenCleanPro Algaecide has to be classified as hazardous for shipping purposes. However, this product on a consumer level is perfectly safe for humans, animals, and fish.
GreenClean Pro Algaecide is labeled for use in "swimming areas" but GreenClean Pro Algaecide cannot be used in chlorinated pools.
GreenClean Pro Algaecide is safe to use in your unlined pond. You would want to use 1-3 tsp per 1000 gallons water. Your pond appears to have approx. 12000 gallons of water. So, you would use approz. 24 tsp to treat your pond.
GreenClean Pro Algaecide is safe to use in ponds where fish live as long as the product label is followed.
GreenClean is not specifically labeled for Naiad so we are not sure if it will be effective or not. However, the manufacturer is the expert on their own product and should know the answer to your question. The manufacturer is BioSafe Systems and you can reach them at: 888.273.3088.
Dependant on what type of moss growing if Green Clean Pro will treat it. Please contact your Local Cooperative Extension Office for identification. After identified, we can be sure to recommend the correct product to you.
Per the GreenClean Pro Algaecide product label, you can re-treat as needed whenever re-growth begins to appear, allowing at least 48 hours between consecutive treatments.
The valve on the 50lb bag of GreenClean Pro Algaecide is to vaccum seal the product for freshness and should not be used for application purposes.
GreenClean Pro algaecide is for ponds, lakes, gardens, fountains, ornamental waterfalls, ground surface water, etc not for use in greenhouses nor to kill fungus gnats. We do have the 1300 Orthene TR Micro Total Release insecticide that is labeled for use inside greenhouses and is labeled to tr…
Read Full Answer »The water pump needs to be running when using GreenClean Pro Algaecide. This will allow the product to work properly on the algae inside of the pond. The mixing ratio is 1-3 teaspoons per 1000 gallons of water.
For heavy algae growth you would use 20-90 pounds of GreenClean Pro Algaecide per acre-foot of water. Given your measurement, it appears that your pond is about 1.38 acre foot.
To our knowledge, GreenClean is not OMRI or CCOF certified. We do not know of an Algaecide that is.
Yes, GreenClean Pro Algaecide is labeled for use on roofs.
You can use the GreenClean Pro Algaecide in your pond following the instructions on the product label.
The rate of GreenClean Pro Algaecide is 20-90 lbs per acre foot of water for heavy algae growth. For low/moderate growth, the rate is 2-9 lbs per acre foot of water. Be sure not to treat your entire pond at once so that the oxygen in the water is not depleted.
While the GreenClean Pro Algaecide does produce carbonate in the water, which can raise the pH (increase alkalinity) of the treated water naturally, this product is not labeled to be used specifically for this purpose. Therefore, we cannot advise you to use the product for this use. You can contact …
Read Full Answer »GreenClean Pro algaecide is for ponds, lakes, gardens, fountains, ornamental waterfalls, ground surface water, etc not for use in greenhouses.