Killzall Weed and Grass Killer - 41% Glyphosate is a non-selective post-emergent, herbicide which already includes a surfactant, and will provide control for most annual and perennial weeds, brush, and grasses - including violets. However, for your crepe myrtle suckers, you may consider using Sucker Punch Ready To Use, which is specially labeled for use on ornamental trees and other woody plants and stops sprouting suckers from pruning cuts and roots of ornamental trees and other types of woody plants.
Killzall Weed and Grass Killer - 41% Glyphosate should not be used in areas that are intended for grazing and on or around edible feed or food crops.
Hi-Yield 2, 4-D Selective Weed Killer can be used for broadleaf control in pasturelands where there are grazing animals however you would need to wait a minimum of 30 days after application before allowing animals back into the treated area. If you are applying in a non-grazing area, they would need to be kept out of the area while spraying and until the product dries completely.
Killzall Weed and Grass Killer - 41% Glyphosate is not labeled for intended use in grazing areas or food plots for deer. If treating lawns or pasturelands for non grazing uses, once the application has dried completey, it would be safe for animals to enter the area.
Yes, Killzall Weed and Grass Killer - 41% Glyphosate is a non selective herbicide that not only kills annual and perennial weeds, turfgrass, brush, and harder to control weeds but will also kill or injure desriable flowers, roses, bushes, shrubs, and turfgrasses.
If treating weeds around desriable flowers or roses, we recommend carefully spot treating the weeds directly. Do not apply when spray drift can occur and use a protective barrier if needed to prevent overspray such as a piece of cardboard or plastic.
Please view the full product label for more information.
Killzall Weed and Grass Killer - 41% Glyphosate is a non-selective herbicide and will weeds as well as turfgrass. This is commonly used for direct spot treatments for weed control and any barespots in the lawn can be reseeded or resodded after 2 weeks.
Depending on the weeds you are targeting, Atrazine or Blindside WDG are commonly used for post emergent weed control in St. Augustine.
Please view our St. Augustine Lawn Guide for more information.
Killzall Weed and Grass Killer - 41% Glyphosate is a roundup type product that will kill just about anything it touches that is actively growing. It is not a pre-emergent herbicide.
Killzall Weed and Grass Killer - 41% Glyphosate is a non-selective so will kill what is sprayed so avoid desired muscadine vines when spot treating that area very carefully.
Killzall Weed and Grass Killer - 41% Glyphosate is labeled for kudzu at the rate of 2.5 fl oz per gallon of water. A second follow up application may be required for harder to kill vines.
For kudzu vines that are growing up a pole, fence or mature tree trunk, cut vine to a height of 3 to 4 feet and spray thoroughly covering remaining vine. If vine is climbing a shrub or immature (green) tree trunk, to avoid damage to these plants, cut vine at base and treat as directed for stumps or spray regrowth. If spraying regrowth, shield shrub or green trunk from drift with a sheet of plastic or cardboard.
Please review the full product label for more information. s.
We would not recommend tilling or incorporating any dead vegetation that has been treated with Killzall Weed and Grass Killer. Any dead vegetation should be manually removed 2 weeks following the application and prior to planting a vegetable garden.
Killzall Weed and Grass Killer - 41% Glyphosate is applied at 2.5 oz per gallon of water (1 gallon treats approx. 300 sq. ft.)
Please view the full product label for more information.
The application rate for Killzall Weed and Grass Killer - 41% Glyphosate is 1.5 to 2.5 fl oz per gallon of water per 300 sq ft.
The 16 oz pint will cover 1,920 sq ft to 3,200 sq ft and the Gallon (128 fl oz) is going cover 15,360 sq ft (0.35 acre) to 25,600 sq ft (0.58 acre)
Please view the product label for recommended rates and more information.
According to the manufacturer's label, for best results use 2.5 fl. oz. (5 Tbs.) of Killzall Weed and Grass Killer - 41% Glyphosate per 1 gallon of water to treat approximately 300 sq. ft. of area.
For covering 3,000 sq. ft. of area, you would need 10 times 2.5 fl. oz., which would be 25 fl. oz.
Bamboo is extremely stubborn, so it can take several steps to remove it completely. You can use Killzall Weed and Grass Killer - 41% Glyphosate at the highest listed usage rate to help eliminate bamboo. You will be required to cut the bamboo down to a short stump and then apply the Killzall. It can take several applications to achieve the desired results. While there is nothing that will prevent it coming back you would need to treat it again if it does.
You will need to wait at least 2 weeks to plant any type of seed after using Killzall Weed and Grass Killer - 41% Glyphosate.
Killzall Weed and Grass Killer - 41% Glyphosate is labeled for poison oak but not directly labeled for the California Wild Grape.
The active ingredient Glyphosate is a non selective herbicide known to be effective for California Wild Grape but will also kill any surrounding vegetation.
For California Wild Grape, fall applications are best when the vines are preparing for winter dormancy and actively transporting nutrients back into their roots. Immediately after cutting the vines, paint the freshly cut surface with the herbicide undiluted.
View the product label for more information.
Killzall Weed and Grass Killer - 41% Glyphosate should not be used in pastures or where there are grazing animals.
Garlon 4 Ultra Herbicide could be an alternative product for killing annual and perennial weeds along with woody plants along fence lines to pastures where there are grazing animals. There are no grazing restrictions.
View the product label for additional information.
