Navigator SC is a professional-grade termititicide that contains 9.1 % fipronil as its active ingredient. It is used for both pre- and post-construction subterranean termite control, as well as for outdoor control of other perimeter pests such as ants, centipedes, spiders, ticks, and roaches. See label for a complete list of pests.
Concrete Slab (Including Monolithic, Floating and Supported Concrete Slabs) on Ground or in Basements and Crawl Spaces, Hollow Block Foundations or Voids, Basement Structures, Accessible Crawl Space Construction, Inaccessible Crawl Space Construction.
Pre- and post-construction (including exterior perimeter/localized interior treatment) applications for subterranean termite control, Above ground applications for dry wood termite control, outside surfaces and along foundation perimeters.
Yes, if used as directed on the label.
NOT FOR SALE TO
CT, NY, VT (Restricted To Licensed Applicators Only)
5.00 x 2.50 x 8.00 inches.
It controls termites and provides residual control for protection against future infestations.
This pesticide is toxic to birds, fish, and aquatic invertebrates. For terrestrial uses: DO NOT apply directly to water or to areas where surface water is present or to intertidal areas below the mean high watermark. Runoff from treated areas may be hazardous to aquatic organisms in neighboring areas. Care must be taken to avoid runoff. DO NOT contaminate water by cleaning equipment or disposal of wastes. DO NOT contaminate water when disposing of equipment wash waters or rinsate.
DIRECTIONS FOR USE
It is a violation of federal law to use this product in a manner inconsistent with its labeling.
DO NOT USE THIS PRODUCT TO FORMULATE, REFORMULATE, OR REPACKAGE INTO ANY OTHER PESTICIDE PRODUCT.
For sale to, use and storage only by individuals/firms licensed or registered by the state to apply termiticide products. States may have more restrictive requirements regarding qualifications or persons using this product. Consult the structural pest control regulatory agency of your state prior to use of this product.
Read entire label before using this product.
SHAKE WELL BEFORE USING
For Use for Control of Termites
When treating adjacent to an existing structure, the applicator must check the area to be treated, and immediately adjacent areas of the structure, for visible and accessible cracks and holes to prevent any leaks or significant exposures to persons occupying the structure. People present or residing in the structure during application must be advised to remove their pets and themselves from the structure if they see any signs of leakage. After application, the applicator is required to check for leaks. All leaks resulting in the deposition of termiticide in locations other than those prescribed on this label must be cleaned up prior to leaving the application site.
DO NOT allow people or pets to contact contaminated areas or to reoccupy contaminated areas of the structure until the cleanup is completed.
Prior to drilling and treating through concrete structures, such as patios, porches, sidewalks and foundation slabs applicator should first determine that there are no habitable areas below that could be unintentionally contaminated by the treatment.
Only protected applicators wearing personal protective equipment as required by this product label may be in the area during application.
All holes in commonly occupied areas into which Navigator SC Termiticide/Insecticide has been applied must be plugged. Plugs must be of a non-cellulose material or covered by an impervious, non-cellulose material.
DO NOT apply finished dilution of Navigator SC Termiticide/Insecticide until all heating/air conditioning ducts, air vents, plumbing pipes, sewer lines, floor drains, heating pipes and electrical lines/conduits are known and identified. DO NOT puncture or contaminate any of these.
DO NOT treat within a distance of one foot out from the drip line of edible plants.
DO NOT contaminate public and private water supplies.
DO NOT make treatments while precipitation is occurring.
DO NOT treat soil that is water-saturated or frozen.
Use anti-backflow or air gap equipment with filling hoses.
Mix Navigator SC Termiticide/Insecticide with water in the following manner:
Fill mix tank 1/4 to 1/3 full with water. The filling hose must be equipped with an acceptable anti-backflow device, or the water flow must include an air gap to protect against back siphoning.
Start the pump to begin by-pass agitation and place the end of the treating tool in the tank to allow circulation through the spray hose.
Add the appropriate amount of Navigator SC Termiticide/Insecticide required to prepare the dilution.
Add the remaining amount of water.
Continue to run the pump allowing recirculation through the hose back into the tank until the Navigator SC Termiticide/Insecticide is completely dispersed.
*See label for the complete list of application rates.