California / New York Indoor Ant Kit

Before applying insecticides, it is important to inspect and to prepare the treatment area. Practice good sanitation by eliminating food and water sources that may compete with the baits you are about to apply. Also find ways to seal up and eliminate access points into the structure. These steps will help not only to treat an existing infestation, but also to prevent future problems. Once you have identified the hot spots where ants are entering or trailing indoors, you are ready to use the products in your California / New York Indoor Ant Control Kit.

How to Apply the California/New York Indoor Ant Kit

STEP 1 - BAIT - Bait Plate Stations, Advance 375A Select Granular Ant Bait, Advion Ant Bait Gel

*Handle bait stations with clean, dry hands or wear gloves. Avoid handling bait with bare hands as this may make baits less palatable.

*Your kit includes a set of 12 bait station bases, 12 lids, and 12 glue dots. Pull apart the stacks to separate the components. Each base is a tray with two ridged channels so that you can use two different baits in each bait plate station.

*To apply the Advance 375A Select Granular Ant Bait, first unscrew the top to remove the seal under the cap. Then flip open the “spoon” side of the cap and use a dedicated or disposable tool such as a plastic spoon to scoop a small amount of the bait granules into each station. Use 0.5 oz. (1 Tablespoon) of bait in one side only of each bait plate station you plan to set out. (Keep the other channel empty for the gel bait.)

*Be sure to store bait in a cool, dry place with the lid securely closed.

*To apply the Advion Ant Bait Gel, first gently unscrew the solid blue tip of the tube you would like to use. Replace this tip with one of the longer clear or blue reusable tips included with your kit. Use either a bait gun or the included plastic plunger to gently expel the gel from the tube, similar to using a syringe. (You may need to pull back gently on the plunger to prevent over-application.) Place a spot of bait about the size of a pea in the other side of each bait plate stations you plan to use.

*When you are done applying the Advion Ant Bait Gel, replace the long plastic tip with the smaller blue solid tip to store bait.

*After you have filled your bait plate station trays, snap a lid onto each one by lining up the U-shaped tab and the round tab with the corresponding parts in the tray. Gently press the edges of the lid until it is firmly snapped into the tray, being careful not to tilt the trays, which may cause granule bait to spill. It is not necessary to remove the perforated tab from the bait plate station lids.

*You should place bait in areas where ant activity has been noticed. It is important to avoid purposefully putting the bait in the middle of an ant trail or onto the ants themselves: this will make the ants avoid the bait and make the baiting ineffective. Instead, put the bait near ant activity or next to ant trails. Some examples of places where the bait can be placed are:

• In kitchen cabinets and on counter tops.
• Behind, next to, and under the stove.
• Near sinks or drains
• Around pipes, cords, and cables that come out of the wall.
• Behind and under bathroom fixtures.
• Around the medicine cabinet and vanity.

*You should check the bait placements once a week and replenish as needed until ant activity has ceased.

*Store baits in a dry, temperate area, out of direct sunlight. Baits are best used within a year of opening.

*Bait stations may be wiped clean and washed with warm water for reuse later. Do not use fragrant cleaners, as this may make future bait applications unattractive.