Ferti-lome Brush Killer Stump Killer is recommended for the control of unwanted woody plants, vines and broadleaf weeds around homes, cabins, fences, walkways, and other non-crop areas.

Stump Treatment

To kill Stumps and prevent sprouting, apply the undiluted product with a paint brush or backpack sprayer to completely cover the freshly cut surface. Do not reuse paint brush. Wrap in several layers of newspaper and discard in trash.

Vine Control

When treating Vines such as Poison Oak, Poison Ivy, etc. that grow on or around desirable Plants, do not allow spray to contact desirable vegetation. Cut the Vine first and treat as directed for Stump treatment.

Foliage Spray

Using a hose-end or tank sprayer, mix 8 to 16 tablespoons (4 to 8 fl. oz.) in enough water to make one gallon mixed spray. For mature or hard-to-control Plants (such as Ash, Blackgum, Choke Cherry, Elm, Maple, Oak, Pine, or Winged Elm), or during drough conditions, use the highest rate of application indicated. Resprouting may occur in the year following treatment when lower rates are used. The addition of a surfactant (spreader/sticker) enhances herbicidal action and improved distribution of the spray on hard-to-wet Plant surfaces. Apply at the rate of one gallon mixed spray to approximately 500 sq. ft. of area. Coverage may vary depending on the amount of foliage to be treated. Using coarse spray pattern and low pressure, apply as thorough foliage spray to wet all leaves.