Premise Pro Insecticide provides superior protection for pre-construction treatment against subterranean, drywood and dampwood termites. This is a non-repellent product where termites cannot detect the formula and comes into contact with the active ingredient, Imidacloprid. It is not harmful to plumbing like other termiticides. Comes in an easy to measure suspension formula that results in minimal agiation. This product also targets against carpenter ants and other wood infesting insects. Termites cannot detect in the soil due to the non repellent formula.
Refer to Mixing Table for proper amount of Premise Pro Insecticide to be used. Mix the termiticide use dilution in the following manner.
Fill tank 1/4 to 1/3 full. If using large sprayer, start pump to begin bypass agitation and place end of treating tool in tank to allow circulation through hose. Add appropriate amount of Premise Pro Insecticide. Add remaining amount of water. Let pump run and allow recirculation through the hose for 2 to 3 minutes.
MIXING TABLE FOR PREMISE PRO INSECTICIDE
GALLONS OF WATER 0.05% Concentrate 0.10% Concentrate
50 6.3 fl. oz 12.5 fl oz
100 12.5 fl oz 25 fl oz
200 25 fl oz 50 fl oz
1000 123 fl oz 246 fl oz
CONVERSION KEY: 128 fl oz = 1 gal, 16 fl oz = 1 pint, 8 pints = 1 gal, 1 fl oz = 29.5 mL
Premise Pro is a very cost-effective solution for termite Pretreatments compared to Termidor or other products like Phantom. It requires very little concentrated product to mix for 50 gallons. However, if you're doing a "correct" soil treatment be prepared to use upwards of 300 gallons of finished product per product label. I wouldn't recommend Premise for any other treatments except maybe ants, since it is a non-repellant. Professional pest control company owner here.