APPLICATION INSTRUCTIONS:

Spray application for home garden plants:

Mix 1 tsp. per gallon of water and apply directly to plants using a hand pump sprayer or other spray equipment. Spray sufficient amount to wet all leaves and fruit with minimal run-off or dripping. Total coverage depends on the size of plants to be sprayed and the type of sprayer used. Repeat when necessary to maintain disease control, normally every 7-10 days. If disease is prevalent or environmental conditions such as high humidity favor disease outbreak, increase the mixing rate to 1 tablespoon per gallon and shorten the interval between sprays to every 3-7 days.

Drench application:

Mix 1 teaspoon of Garden Friendly Fungicide per gallon of water and apply to the soil by one of the following methods:

1. For potted plants (indoors or outdoors), apply in sufficient water to wet the entire root mass using a watering can or tank-fed watering wand. Do not water plants again until 24 hours after application. Alternatively, use a hand-pump or other sprayer to spray the mixture on the soil surface in each pot, then immediately apply sufficient water to move the product into the roots.
2. Drench the roots of transplants with approximately 4 fluid ounces of the mixture immediately before transplanting into pots or garden soil. Allow to soak into the root ball before transplanting.
3. For outdoor-grown plants, use a watering can or sprayer to drench the soil in the planting furrow or transplant hole immediately before planting or transplanting. The amount of water required will depend on the size of the hole or length of furrow.
4. Alternatively, apply in the first watering after planting or transplanting, either by mixing directly into the water at the rate indicated above, or by spraying onto the soil surface at the base of each plant and immediately watering in with a watering can, hose, sprinkler, or other watering device. Garden Friendly Fungicide can be applied up to and including the day of harvest.

For application to lawns and other grass areas:

Mix 1 teaspoon of Garden Friendly Fungicide per gallon of water and apply as a fine spray to the surface of the lawn or grass area. Total amount of mix required will depend on the type of sprayer used and area to be covered, but typically 2 to 5 gallons of spray mix may be required per 1,000 square feet of lawn. Garden Friendly Fungicide can be “watered in" for control of soil borne root and crown diseases by thorough watering immediately after application either with sprinklers or by spraying just before or during light rain.