ROTATION (PLANTBACK) RESTRICTIONS

REPLANTING

If replanting is necessary, additional applications of this product may be made, provided that the total amount of mefenoxam applied does not exceed the maximum application rate or the seasonal amount allowed for the specific crop.

ROTATION (PLANTBACK) RESTRICTIONS

Do not plant any crop that is not registered for use with mefenoxam in mefenoxam-treated soil for a period of 12 months unless a shorter interval is specified on the following list.

• Alfalfa (including birdsfoot trefoil)
• Asparagus
• Brassica (Cole Crop) Vegetables (e.g., broccoli, cabbage, cauliflower)
• Clover
• Cotton
• Cucurbit Vegetables
• Fruiting Vegetables
• Garlic
• Globe Artichoke
• Herbs (fresh and dried)
• Leafy Vegetables except for Brassica (e.g., lettuce, spinach, celery)
• Legume Vegetables (e.g., beans and peas, succulent and dried)
• Onions (dry bulb, green)
• Peanuts
• Pineapples
• Root and Tuber Vegetables
• Soybeans
• Strawberries
• Sunflower
• Cereal Grains (other than Corn)
• Corn
• Crops Not Intended for Food or Feed
• All Other Crops Intended for Food or Feed

MIXING PROCEDURES

Add 1/4 to 1/2 of the required amount of water to the spray tank, add the proper amount of this product, then add the rest of the water. When tank mixing other products with this product, follow the proper sequence of adding products to the spray tank. Wettable powders or water-dispersible granules should be added to the water in the tank first, followed by flowable products, with emulsifiable concentrates, such as this product, added last. Provide sufficient agitation during mixing and application to maintain a uniform emulsion.

Unless otherwise prohibited on this label or the label of an intended tank mix product, this product may be applied in combination with any pesticide registered for the same crop, timing, and method of application. Observe the most restrictive label statements of various tank mix products used.

IMPORTANT: PESTICIDE TANK MIXES MAY INCREASE THE RISK OF MIXING INCOMPATIBILITIES, REDUCED EFFECTIVENESS AND/OR CAUSE CROP INJURY OR LOSS.

GENERAL APPLICATION INSTRUCTIONS

Apply this product by ground or air in sufficient water or liquid fertilizer to provide uniform coverage of the soil surface. Apply in a minimum of 20 gallons per acre for ground applications and 5 gallons per acre by air. Refer to the specific crop application directions.

Banded Applications: For banded applications, the area actually is the area covered by the band, not total cropland area planted. Some row-crop directions are based on treating in-the-row and these rates generally are specified as amounts (fluid ounces) of product per certain row length (often 1,000 feet). Others express rates as the amount per treated acre, which means the total area treated with the pesticide. If rates are expressed as an amount per treated acre and banded applications are used, the amount of pesticide used per acre will be proportionately less. The following formula can be used to calculate the amount of this product needed per acre of the crop when banded applications are made.

In-Furrow Applications: For in-furrow applications, apply this product as an in-furrow spray in 3 to 7 gallons of water per acre at planting. Mount the spray nozzle so the spray is directed into the furrow just before the seeds are covered. Following is a table of the common row spacings and the amount of this product applied per acre.

*See label for the complete list of application rates.