Since Demand CS is a non-selective insecticide, it could potentially kill dragonflies that are exposed to enough of the active ingredient. Dragonflies will feed on smaller flying insects, so if you are already minimizing populations of these insects, then you will be less likely to find their predators in the area. The best way to minimize harming these insects would be to avoid spraying insecticides while they are most active during times of more sunlight.
First, you need to determine how many gallons of water you will be using. To find out how many gallons of water you need to use you will calculate the square footage of the area to be treated (Demeand CS recommend 1 gallon of mixed solution 1,000 sq feet). For instance, if you have a 6,000 square foot yard that you plan on treating then you would need to multiply 6 x 0.8 which equals 4.8 - You would then add 4.8 oz of Demand CS to the reservoir. Once you add the desired amount of Demand CS to the reservoir, then you would add water to the line selected (6 gallon line mark on the reservoir). You would then set the dial on the top of the Chapin Hose End Sprayer to 6 gallons. Do not turn water on when adjusting the spray nozzle. Next, select the desired spray pattern and then spray until the reservoir is empty.
Demand CS is not labeled to treat for dust mites. We would recommend something like Bedlam Insecticide Aerosol instead. Please see our Dust Mite Control Guide for more information on treating and preventing this type of pest.
To achieve 0.06% active ingredient in Demand CS mixed solution, you will need to use 0.8 oz. per gallon of water.
Demand CS specifically states on the product label do not apply to sewer so would not be recommended.
Demand CS cannot be applied to anything edible. Any edible vegetation that was sprayed with this product should be discarded and not eaten.
Generally speaking, all insecticides need to be kept at room temperature area to prolong shelf life. You don't want to expose any insecticide to direct sunlight, high heat or freezing temperatures, as this could break the product down, and it will lose effectiveness. If your bottle of Demand CS was left outside for a week, there is a good chance it could be ok, depending on what the temperatures were that week. If the product isn't seperated at all or clumpy and mixes well with water, then it should still be fine to use, but it may not have the residual that it had before these conditions.
Demand CS is labeled for flies. Please take a few moments to review our treatment article on How to Get Rid of Flies for additional information on a successful eradication program.
Demand CS should not be applied to edible vegetation. Please take a look at our selection of Edible Gardening products to find a product that will work for your needs.
When using Demand CS to treat Japanese Beetles, the mix rates vary depending if you are treating the lawn or ornamentals. Please refer to the product label for application instructions.
Lawn Mix Rates: 3.4 - 7ml (0.1 to 0.2 fl oz) per 1,000 square feet / 5-10 fl per acre
Ornamental Rates: 0.4 - 1.3ml (1.5 to 5fl oz) used in 25 gallons of water.
For spot treatments, use 0.5 fl oz Demand CS Insecticide per 1–2 1/2 gal of water.
Since water is acting as the carrier, each treatment and the amount of water that will be used is specific to the individual treatment. Please take a moment to review our How to use the Chapin Wet or Dry Hose End Sprayer Video for tips on how to set the dial for this sprayer.
No, it is not recommended that you mix two insecticides together. This would essentially be doubling up on the product and may cause the adverse effect.
A good option would be to use PT Alpine Pressurized Fly Bait in the area where you are having an issue. Apply inside all garbage receptacles, underneath garbage lids, inside recycling bins or receptacles, and other labeled areas that will help prevent flies from being a nuisance.
Demand CS is labeld for Pine Shoot Beetles and to be mixed at 1.5-5 fl oz/ 100 gallons of water. Please refer to the product label for complete application instructions and consult your local cooperative extension office for specific application timing in your area.
Yes, Nyguard IGR and Demand CS can be mixed and used together. You will use 0.2-0.8 oz. of Demand and 4-12 mL of Nyguard per gallon of water, depending on what pest(s) you are treating for. Typically one gallon of mixed solution will cover about 1000 sq. ft.
Demand CS can last 60-90 days on outside surfaces so generally is applied once a quarter. If needed it can be applied as a spot treatment every 7 days per the product label.
Demand CS has a shelf life of about 3 to 5 years when stored in a cool dry area. D-Fense Deltamethrin Dust has a shelf life of 3 years from the date of purchase.
Yes, Demand CS is labeled for carpenter ants and will kill any carpenter ants that come in contact with a treated surface. It is micro-encapsulated, so it works like a time released formula. For carpenter ant control specifically, we would recommend our Indoor Carpenter Ant Kit. The kit contains professional pest control products to control carpenter ants found inside structures, including two baits that contain different formulations and active ingredients to increase bait acceptance and efficacy. To control carpenter ants around the exterior of your home, Taurus SC will do the trick. You would mix 0.8 fl. oz. of Taurus SC per gallon of water and apply using a hand-pump sprayer around the outside of the home, spraying 1 foot up the side of the house and 1 foot out from the house, all the way around the home.
We are sorry to hear that your pet is sick. If you suspeect your pet is having a reaction to Demand CS, please contact the manufacturer Syngenta at 866-796-4368, as well as your pets Vet.
Demand CS is mixed at the rate of 0.2 to 0.8 fl oz per gallon of water. If using in less (such as in ½ gallon) that rate would be halved to 0.1 to 0.4 fl oz.
Demand CS should not be applied directly to new plants. You can treat the areas surrounding them safely.
Yes, Demand CS can be applied using just about any type of sprayer including a hose end sprayer. The hose end sprayer needs to be able to be calibrated to 0.8 fl.oz. (24mL) of product per gallon of water.
