Killzall II Weed and Grass Killer is an excellent solution against unwanted annual and perennial broadleaf weeds. Contains glyphosate as its active ingredient which is known for effectively killing broadleaf weeds and grasses. It is hassle-free to apply since it mixes readily with water to be used as a foliar spray. The Killzall II Weed and Grass Killer is a non-selective weed and grass killer that comes with a double surfactant formulation that easily dries on plants, making it fast-acting. It is proven safe to use in paths, patios, near fences, curbs, driveways, sidewalks, around buildings, ornamental trees, flower beds, and shrubs. A highly effective herbicide that is specifically labeled for brush and vine control, stump treatment, and lawn renovation. For better results, it is recommended to use 3 tablespoons per gallon for general weed control and 5 tablespoons per gallon for tough weed control. Packaged in a 2.5-gallon jug container.
Do not apply directly to water, to areas where surface water is present, or to intertidal areas below the mean high water mark. Do not contaminate water when disposing of equipment washwaters or rinsate.
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area at the time of application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulations.
Weed Resistance Management Directions
Glyphosate resistant biotypes can be minimized by utilizing the following weed resistance management instructions:
Begin by preparing your field using tillage or a burndown herbicide application.
It is a good practice to scout your fields before and after applications.
Use new commercial seeds that have fewer weed seeds.
Apply early control of weeds that are relatively small.
Cultural practices such as crop rotation or tillage and the addition of other herbicides such as a selective and/or a residual herbicide where appropriate are suggested.
Rotating to other Roundup Ready crops is one method for adding other herbicides into a continuous Roundup Ready system.
Follow the specified label rate for the most difficult to control weeds. Reject directions that support lower application rates when tank mixing as well as tank mixtures with other herbicides that will reduce product efficacy.
Follow good agricultural practices by cleaning equipment prior to shifting from field to field preventing weed seed or plant root parts from spreading.
Any incidence of repeated non-performance of this product on a particular weed should be reported to any Voluntary Purchasing Groups, Inc. representative, your county extension agent or to the local retailer.
Spray solutions of this product should be mixed, stored and applied using only stainless steel, aluminum, fiberglass, plastic or plastic-lined steel containers.
DO NOT MIX, STORE OR APPLY THIS PRODUCT OR SPRAY SOLUTIONS OF THIS PRODUCT IN GALVANIZED STEEL OR UNLINED STEEL (EXCEPT STAINLESS STEEL) CONTAINERS OR SPRAY TANKS.
*See label for the complete list of mixing instructions.
When applied as specified under the conditions described for Wiper Applicators, this product CONTROLS the following weeds:
When applied as specified under the conditions described for Wiper Applicators, this product SUPPRESSES the following weeds:
This product may be used in aerial or ground injection spray systems. It may be used as a liquid concentrate or diluted prior to injecting into the spray stream. Do not mix this product with the concentrate of other products for use in injection systems.
This herbicide controls many annual and perennial grasses and broadleaf weeds.
Apply to actively growing grass and broadleaf weeds.
Allow at least 3 days after treatment before tillage.
For maximum agronomic benefit, apply when weeds are 6 inches or less in height.
To prevent seed production, applications should be made prior to seedbed formation.
This product does not provide residual control; therefore, delay application until maximum weed emergence. Repeat treatments may be necessary to control later germinating weeds.