Save! Get 48 for only $0.69 each
Have a Question? Ask Our Pros!
Protecta MC Glue Boards are designed to be used in the Protecta Multi-Catch Trap and the Protecta Pest Monitor. These glue boards may be used in traps or alone. Glue boards in conjunction with traps are great for situations where poisons are prohibited or discouraged. These boards measure 4" x 6.75". You may also use the Protecta MC Glue Boards alone to catch mice and insects.
NOT FOR USE OUTDOORS
| Target pests | Rats, Mice, and Insects |
|---|---|
| For use in | Designed to be used in the Protecta Multi-Catch Trap and the Protecta Pest Monitor or alone laying flat. Situations where poisons or snap traps are prohibited or discouraged, Residential, commercial, or industrial buildings, indoors in places not readily accessible to pets and children. |
| Application | Place near baseboards, corners, along walls, or in spaces where pests are likely to travel. |
| Pet safe | Vegetable oil will dissolve the glue if needed. Should be used in places not readily accessible to pets and children. |
| Dimensions | 6.75 in. Length x 4 in. Width |
| Material / Construction | Disposable cardboard |
| Special Features | Large catching surface area and maximum holding power to ensure a high capture rate for rats, mice and insects. |
| Shipping Weight | 1.52 lbs |
| Manufacturer | Bell Labs (Mfg. Number: MC2600) |
![]()
Sticky traps work!
By Cheryl on 06/06/2011
These work very well. We staple them so the rats can't run away.
![]()
Glue Boards
By Russell on 11/11/2011
Boards are nice and sticky for crickets, my big problem. Peel sheet is a little difficult to remove only problem.
![]()
question
By Sherrell on 01/13/2013
I use sticky pads designed for mice in my garage to catch anything that crawls. So far, I've caught spiders and snakes. Are these sticky enough for snakes?
The Protecta (Trapper MC) Glue boards measure 4" x 6.75" and are made to fit inside the Protecta Pest Monitor Trap or they can be used by themselves without the trap.
The Protecta (Trapper MC) Glue Board adhesive can be removed by using vegetable oil. You will need to rub it over the areas where the adhesive is present.