DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

FAILURE TO FOLLOW THE USE DIRECTIONS AND PRECAUTIONS ON THIS LABEL MAY RESULT IN PLANT INJURY OR POOR DISEASE CONTROL.

DO NOT apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation. 

TURF

Segway controls Pythium blight, Pythium damping-off, Pythium root dysfunction, and Pythium root rot in the turf. Within the rate range given for turf, use the lower rate for the shortest interval and higher rate for the longest interval. Under severe disease conditions, use the highest rate and shortest interval. Use only with ground application equipment. 

Do not apply more than three applications of Segway at the high use rate during any growing season. Do not apply more than two consecutive applications of Segway. Subsequent applications should be alternated with another registered fungicide with a different mode of action. Do not apply more than 2.7 fl. oz./1000 sq. ft./year (3.0 lb a.i./acre/year).

For Application to Turf

• Pythium blight, Pythium damping-off
  • 0.45 to 0.9 fl. oz. per 1000 sq. ft.
  • 14 to 21 days interval
  • Apply as a preventive treatment at 0.45 to 0.9 fluid ounce in 2 to 4 gallons of water per 1000 square feet. On established turf apply as a preventive treatment when conditions are favorable for disease development, or when first visible disease symptoms appear. During periods of prolonged favorable conditions use 0.45 fluid oz. on a 14-day interval. For newly seeded areas use 0.45 fluid oz in 2 to 4 gallons per 1000 square feet immediately after seeding. Under severe conditions use the highest rate and the shortest interval.
• Pythium root dysfunction
  • 0.9 fl. oz. per 1000 square ft.
  • 14 to 28 days interval
  • Apply as a preventive treatment every 21 to 28 days in the fall and spring when mean daily soil temperatures are between 50 degrees F and 75 degrees F. CUrative applications should be made every 14 to 28 days based on the appearance of symptoms. Immediately follow application with 1/8 inch irrigation.
•  Pythium root rot
  • 0.9 fl. oz. per 1000 sq. ft.
  • 21 days interval
  • Apply as a preventive treatment every 21 days. Immediately follow application with 1/8 inch irrigation. 

ORNAMENTALS

Soil Application

For control of damping-off, root and stem rot diseases of ornamentals, including conifers, grown in landscapes, apply Segway as a soil drench or soil surface spray. Do not make more than 2 applications of Segway per crop cycle for control of Pythium or Phytophthora soil-borne diseases.

Foliar Application

For foliar applications, apply sufficient spray solution to thoroughly wet the foliage to the point of run-off (generally not to exceed 100 gallons per acre). Do not apply more than two consecutive applications of Segway during any growing season. Segway should then be alternated with another registered fungicide with a different mode of action. Do not make more than 4 applications of Segway per crop cycle for control of downy mildews or Phytophthora foliar diseases.

Applications of Segway should begin when conditions are favorable for disease development or when plants first exhibit disease symptoms, from germination to mature crop.

For Application to Ornamental Plants

• Pythium crown and root rots and damping-off
  • 1.5 to 3.0 fluid oz.
  • Make applications on a 14 to 28-day interval using another registered fungicide with a different mode of action between applications of Segway. Within the rate range, use the lower rate and shortest interval and the higher rate at the longest interval. When the disease is severe use the highest rate at the shortest interval.
• Phytophthora crown and root rots and foliar blights
  • Make applications on a 14 to 28-day interval using another registered fungicide with a different mode of action between applications of Segway. Use the shortest interval when disease conditions are severe. For foliar applications, apply sufficient product to wet all foliage to the point of run-off (generally not to exceed 100 gallons per acre).
• Downy Mildews 
  • 2.1 to 3.5 fl. oz.
  • Apply on a 14 to 21-day schedule 9refer to the additional directions given in the Foliar Applications paragraphs above). Within the rate range, use the lower rate at the shortest interval and the higher rate at the longest interval. When disease conditions are severe use the highest rate and the shortest interval. Apply sufficient volume (normally 50 to 100 gallons per acre) to wet all foliage to the point of run-off. If water volumes used are less than 50 gallons per acre, an organosilicone surfactant should be added when the disease infection is severe, or non-ionic surfactant or a blend of an organosilicone and a non-ionic surfactant should be added when disease infection is moderate or light, according to the manufacturer's label recommendations.