Pre-clean all surfaces prior to application of the disinfectant solution. All inanimate surfaces must be thoroughly wetted and remain wet for 10 minutes for disinfection. Then wipe up excess or allow to air dry. Fresh solution must be prepared daily and when use solution becomes visibly dirty. To apply solution for sprayer applications, use as a coarse spray only.
COMMERCIAL FLORIST USE DIRECTIONS:
To clean, disinfect and deodorize hard, non-porous surfaces in one step, prepare use solution by adding 1 1/2 ounces per 5 gallons of water (469 ppm active) (or equivalent use dilution). For heavy-duty use, add 6 ounces per 5 gallons of water (1,875 ppm active) (or equivalent use dilution).
Remove all leaves, petals, garbage and refuse. Pre-clean surfaces using pressurized water where possible. Apply solution to hard non-porous surfaces, thoroughly wetting surfaces as recommended and required, with a cloth, mop, brush, sponge or sprayer.
For heavily soiled areas, a preliminary cleaning is required.
For sprayer applications, use a coarse pump or trigger sprayer. Spray 6-8 inches from surface. Rub with brush, sponge or cloth. Do not breathe spray.
Treated surfaces must remain wet for 10 minutes. Allow surface to air dry.
Prepare a fresh solution at least daily or sooner if use solution becomes visibly dirty.
(See label for complete list of application directions).